(800) 853-2651
SHOP NOW

Recent content by trak

Yesterday's Tractor Forums
  1. T

    For sale WC Allis Chalmers hyd. pump

    have one on my tractor, going to part the tractor out, thought someone might like having period hydraulics, 5802241229 Steve
    $600.00
  2. T

    Case 780 / Case 1150 bucket

    would the 780 bucket fit on a 1150? I have a clam bucket on a 780, wondering if the loader width was the same as an 1150, if it would fit right on with out a whole lot of fab work ty
  3. T

    Track rails/chains

    Wondering, Case 450 or 850 take the same rails as jd350? Think they're 5.850 center too center ty
  4. T

    dh4b case trencher, starting

    hardest thing to start, block heater is over a hundred/kinda hard to find, 44mm,, anyways, im thinking of a dipstick heater, Its the cold hydraulic oil that makes the thing so hard to cold start, idk if you would be better off putting a dipstick heater in the hydraulic tank rather than in the...
  5. T

    JD 555A Hydraulics

    I've had the valve looked at in the past, it may have worked slightly better after new o rings, I'm looking for a fix, if someone has a good valve block, im interested, ty
  6. T

    JD 555A Hydraulics

    bucket drifts down, I'm located between dallas and OKC, pressure's been checked on the cyclinders, not on the valve. Ty
  7. T

    JD 555A Hydraulics

    had the lift cycliders tested, said they're good, I had the control valve looked at in the past, they thought it was ok, gonna need a valve, or a shop that can work on it and test it. ty
  8. T

    New Hollaned 455 mower

    Looking for a pivot arm, 86837518 thx
  9. T

    jd 400 g ad

    says the hi/lo selector needs work, what are some scenario's on that, ty
  10. T

    AC 6G loader rails

    Looking at a 6g, pretty decent shape overall, sprockets look pretty good, rails have lots of wear on the pressure points and have been turned or reversed once,. Need rails, are they available? Ty
  11. T

    2010 jd rollers,

    Parting out,will they fit any other models, 350? Someone may be interested in the rails as they are as new, they want me to throw in the rollers, ty
  12. T

    586E tilt cyclinders

    I'm not having any luck, considering removing the frame brackets, or rebuilding the cylinders on the machine, sending a picture anyways
  13. T

    586E tilt cyclinders

    Ok, might have too rebuild them on the tractor. Ty
  14. T

    586E tilt cyclinders

    The rear of the tilt cylinder, im trying to remove them, I have the keepers out of the pins that go through the cylinder, there's no bind on it, but still won't come out, they'll move back and forth a quarter inch or so, what is holding them?
  15. T

    970, spool valve

    No hitch or pto, removed spool valve, put air through it, always has air going through out port closest to supply, then will put some out furthest hole, not much or none center hole, which could be a return, also, in all the way closed position, seems like leaking air through the spool? Could O...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top