(800) 853-2651
SHOP NOW

Recent content by TylerFarmallH

Yesterday's Tractor Forums
  1. T

    H Demons!

    It has an electronic ignition.
  2. T

    H Demons!

    so I took the advice and removed the carb, cleaning it with air and ran thin wires through all the holes. The motor still lurches and it stalled out under a load. I did a YouTube video of the problem. http://youtu.be/XLdxpcVt2eY
  3. T

    H Demons!

    I am not opposed to trying again but I cleaned it with carb cleaner, an air compressor and a brass wheel.... Is it something I can take out without fully dismantling the carb?
  4. T

    H Demons!

    Guys, My 1946 Farmall H started to act up last winter when I was clearing snow from my drive. The carb float was full of gas so I replaced it and cleaned the carb. I hooked the governor up wrong and had to fix that... It still didn't run right, surging and such, so I replaced the...
  5. T

    H choking itself!

    I literally took the Farmall manual and copied it. I think it was tighten completely and then 2 turns on the idle and 2.5-:3 turns on the main fuel adjustment.
  6. T

    H choking itself!

    Went to bush hog today and my 46 Farmall H is running so rough I couldn't ignore it. Changed the plugs... Readjusted the carb according to Farmall h manual (neighbor has one)... Cleaned out the bottom wing nut adjustment. It is choking it self. I have never seen this. And still runs...
  7. T

    Farmall h carb

    Went to bush hog today and my 46 Farmall H is running so rough I couldn't ignore it. Changed the plugs... Readjusted the carb according to Farmall h manual (neighbor has one)... Cleaned out the bottom wing nut adjustment. It is choking it self. I have never seen this. And still runs...
  8. T

    Farmall 100 questions

    This has been great info thanks. Does anyone know of a picture with a rear view or a Farmall 100 or super a hooked to a single bottom ih plow? We are about to hook it up. Thanks again!
  9. T

    Farmall 100 questions

    Hey guys I am an H owner and during Christmas my father in law has been visiting. We began to discuss his farmall 100 with cultivators. He lives in Florida and has a hard time finding info or parts for it. I have hooked him up with Steiner parts but I wanted to know, are farmall 100's rare or...
  10. T

    Farmall 400 with Electrall

    My neighbor put his Farmall 400 with Electrall on eBay. This might be the only one you get to bid on ;) Look at this on eBay: Farmall-International Harvester 400 with Electrall Generator Very rare tractor You may have to copy and paste the link. Or just search for Farmall 400 with...
  11. T

    Stihl 029 unwanted chain tightening

    The oiler hole on the bar was clogged and a spring that turned the clutch that spun the oil pump was broke. Gonna had to take it in. Thanks guys
  12. T

    Stihl 029 unwanted chain tightening

    It has a screw so I will adjust it to pull loose but still in bar and after some cuts it has no slack at all.
  13. T

    Stihl 029 unwanted chain tightening

    Hey Guys, I have a stihl 029 saw, the chain is tightening after about 4-6 cuts and I have do dissamble the bar and chain and re adjust. I have replaced the bearing and sprocket and still no change. The bar and chain look fine but I guess I'll replace that next? any thoughts?
  14. T

    Help! Farmall 400 12v Conversion

    Yes, it was the strangest thing. There was a black wire not in the diagram that was more than just a ground. Im not sure what the remedy was but it got fixed. Very strange...
  15. T

    Help! Farmall 400 12v Conversion

    Hey guys, these are some pictures and an attached youtube link of my neighbors 400 conversion I am having some problems. I have done this one before succesfully on an H but this one is giving me fits. The Alternator Hot wire is going to the amp Gauge The other line going to amp guage is...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top