Recent content by warren Roberts

  1. W

    Ford 4000 diesel starter

    Please reply to this posting, Sorry fo posting 2X
  2. W

    Ford 4000 diesel starter

    Hi I have a Ford 4000 3 cylinder Diesel. It has been super hard to start for the last couple years. So bad that I have to shoot a small amount of starting fluid into the air cleaner to get it going. Once it starts and runs for a few minutes I can turn it off and on all day without any problems...
  3. W

    Ford 4000 diesel starter

    Hi I have a Ford 4000 3 cylinder Diesel. It has been super hard to start for the last couple years. So bad that I have to shoot a small amount of starting fluid into the air cleaner to get it going. Once it starts and runs for a few minutes I can turn it off and on all day without any problems...
  4. W

    Water in 8 speed trans

    Hi, I have a ford 4000 3 cyl diesel with the 8 speed trans. It keeps getting water in the trans oil. I believe it is leaking in during rain but I cannot find where. There are no rubber boots over the shifter points but I cannot seem to find a part number for them (if they even exist) I am...
  5. W

    Cylinder Sleeves

    Could the parent bore block be verified by the serial or casting #?
  6. W

    Cylinder Sleeves

    Hi: I have a 134CI engine from a 600 series tractor, A few years ago we removed the engine to do a rebuild. I took it to be bored and the machinist said it was too far gone. Shouldn"t there be sleeves in this engine? It did not look to me to that the piston had worn through a sleeve or anything...
  7. W

    Ford 4000 3 point hitch

    Thank You all for your suggestions, I will not be back to my property where the tractor is stored until the 28th of January. I will look at it then and let you know what I find.
  8. W

    Ford 4000 3 point hitch

    The tractor is a 3 cyl diesel. I am not sure about the "Draft" as I have never tried to use it nor would I know how. I replaced the oil about a year ago and I have only had the tractor out 2 or 3 hours since so I am assuming the oil is OK
  9. W

    Ford 4000 3 point hitch

    Hello: The hydraulics on my 3 point hitch have been sporadic lately. It pretty much comes up when it wants. Also there is no middle ground either it is all up or all down. Can someone give me some pointers on how to fix this?
  10. W

    Power steering reservoir bracket

    Yes, But my 600 series had the same bracket so I was assuming it was a fairly universal part. I could make something that will work, But there is nothing like an original part in my book.
  11. W

    Power steering reservoir bracket

    Sorry it is a ford 4000 3 cyl diesel
  12. W

    Power steering reservoir bracket

    Hello All, I am in need of the little square washer that has an indentation to go around the 3/8 rod to support the power steering reservoir. Does anyone have one lying around that they are willing to part with?
  13. W

    Steering cylinder for 4000 industrial

    Does anyone have experience with the steering cylinder on a 4000 industrial tractor? This one has the valve mounted on the cylinder and is actuated by the steering mechanism. I need to know how far the valve needs to move as it seems like it only moves like 1/16 either way.
  14. W

    4000 power steering problems

    OK I fixed the water in tranny problem, this one has been bugging me for a while. I have the power steering cylinder that mounts under the crank pulley. It has a crazy set of levers to move the valve back and fourth as you steer. I cannot seem to get it to work? I checked the pump this morning...
  15. W

    Water in Trans oil?

    Mine is the 3 cylinder diesel
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top