(800) 853-2651
SHOP NOW

Recent content by WD_Fan07

Yesterday's Tractor Forums
  1. W

    generator ID

    They are screws, so it must be an autolite as I suspected. I knew the rear cover was an odd shape for a Delco. Any idea on the number?
  2. W

    generator ID

    This is the generator on my "51 WD. I can"t read the tag because it's worn smooth but it has a Delco-Remy cutout and 3 brushes, I suspect it may be an Autolite though. The rear bushing cover is oblong not a triangle and the band over the brushes is a screw clamp not a clip. Sorry about the poor...
  3. W

    clutches

    Yes the lined clutch disc is what I meant I have seen some with springs around the middle input shaft referred to as a spring clutch disc
  4. W

    clutches

    What are the differences/advantages between button and spring clutches?
  5. W

    mccormick 15-30 governor

    Did McCormicks have poor governors? I have heard of a few 15-30s that had a Heisler or Pickering flyball governor conversion on them. Would anyone know where to find one of these?
  6. W

    robins manifold

    Looking at a mccormick 15-30 to restore which has a Robin(s?) manifold. What"s special about this manifold? I assume it"s an aftermarket part or was it a factory option? Also, what year did the PTO become an option on these tractors? The one I"m looking at is a 1927 with a cover where the PTO...
  7. W

    plow bolts

    Anyone know where to find some of the special bolts for the Bullet Blade shares, the ones with the oval shaped lug on the back of the head? Also, I need some of the bolts with the notch on the head for the slats on a mounted plow
  8. W

    Carb swap

    If I put a TSX 464 carb from a WD45 on a WD would I get more power/better performance or would it get too much gas? I came across a good used one and I"m just curious. I suppose I would need the 45 manifold for full benefit as well.
  9. W

    Orange Spectacular-Hutchinson, mn

    What a great show! I was there for the first time yesterday and I was amazed at how much stuff there was to see. I"ll be back many times!
  10. W

    plow shares

    Does anyone have any new or NOS #325550 or #326080 shares for a #73 slat bottom plow? I would rather not take out a second mortgage and buy them from the AGCO dealer but I might have to.
  11. W

    looking for...

    I"m looking for the guy I talked to last spring about some allis plow parts then was unable to take them. I believe I was going to meet you at the Hutchinson show. I was looking for the slip heel and shares and other various parts. Please get in touch!
  12. W

    plow bolts

    does anyone know where i can get the notched flush-head bolts for the slats on a #73 plow? the parts list i have says the upper ones are part # 924148 (GR. #5) 3/8NC x 1 and the lower ones are # 913512 3/8NC x 1 1/2. i would need 9 of the upper bolts and 15 of the lower bolts (the first slat...
  13. W

    Antique Reel Mower

    I can"t find any, but the back of the right-hand wheel plate says V2 on the top and Made in U.S.A. on the bottom, and the stationary blade says 16 in. and 1931. The left hand wheel says BALL BEARING on the back.
  14. W

    Antique Reel Mower

    Found an old reel mower in a barn and I"m curious about its history. The wheel reads "SIMMONS HOWE CO. OAK LEAF" Anybody know anything about this brand?
  15. W

    Maytag Oil and Fuel

    I recently restored a Maytag Model 92 and I have heard a hundred opinions on type of oil, ratio of oil, type of gas, concerns about alcohol in the gas, etc. I would like to know once and for all what works and what doesn"t. This is a nice engine and I don"t want to ruin it.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top