(800) 853-2651
SHOP NOW

Recent content by WEL

  1. W

    M front end

    Is this a factory or aftermarket front end?
  2. W

    WD45 Power Steering

    Should be 1957 not 1997.
  3. W

    WD45 Power Steering

    Anyone know the first year you could get factory power steering on a WD45? I know it was available on the 1956 and 1997 but don't know if it was available before that.
  4. W

    Water in Oil.

    I have a 1947 Farmall H. Pulled the drain plug to change the oil. Quite a bit of water came out. Other than the head gasket, where else could it be coming from?
  5. W

    H 6 to 12 volt 1 wire Alternator

    Getting ready to convert my H to 12 volt. I am looking at using one of those small diameter denso one wire alternators. Has any one tried using these alternators? Any comments pro or con?
  6. W

    Farmall H Governor

    I'm looking for suggestions for the correct way to set up and adjust the governor on a '47 Farmall H. Any replies will be appreciated.
  7. W

    Farmall H Transmission

    Thanks for the excellent replies. I really appreciate it.
  8. W

    Farmall H Transmission

    I am looking at a 1947 Farmall H. It is a decent tractor but it jumps out of 5th gear. What would be the most likely cause of this issue? Expensive fix? Thanks for any replies.
  9. W

    Farmall H Front End

    I am looking at a 1949 Farmall H with a wide front end. Seller says the wide front is factory. Did the factory make a wide front for a 1949 H?
  10. W

    PTO Clutch

    This clutch is a manually activated clutch. It is adjusted properly but it slips.
  11. W

    PTO Clutch

    The PTO clutch on my 918H Agco-Allis seems to be slipping. Is there any way to repair these clutches? Or does anyone have one they want to sell? All belts are good and mower spindles turn freely. All slipping seems to be in the clutch.
  12. W

    D14 rims

    I have 14.9X28 tires on my D14. Have had no issues at all. The D14 as well as the WD, WD45, D15, D17 and others all have 8 holes on an 8 inch bolt circle with a 6 inch center hole.
  13. W

    wd 45 8' disk and 3-16 plow

    I cannot give away a 3-14 pin couple plow. Next step will be the scrap yard.
  14. W

    Florida Flywheelers Avon Park Rd Feb 19-23

    Hopefully none. The 2 cylinder poppin johnny's bang, bang, pop, pop pssst, pssst noise gives me a headache. They need to stay up north so the snow can muffle their sound.
  15. W

    Russellville Tractor Pull

    What state might this be in?
See more
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top