(800) 853-2651
SHOP NOW

Recent content by wisconsinBill

Yesterday's Tractor Forums
  1. W

    Ford 3000 glow plug

    This message is a reply to an archived post by wvfarmboy54 on April 15, 2013 at 17:08:15. The original subject was "Re: Ford 3000 glow plug". Fast forward to Dec. 2015 and my dealer says they only offer the right turning switch to a "universal" style. Old part numbers cross over to the right...
  2. W

    Distributor cap clip replace

    The distributor cap clip on my Massey Harris 22 has rusted off of the Autolite distributor. Where can I get a replacement clip?
  3. W

    640 Oil Fluids

    Thanks for the support. Hydraulic fluid looked good and fluids seems to hold proper levels so I am going with no big seal leaks. Yes, I did mean 134 hydraulic oil; same as I use in my 1997 2120. I posted on this tractor in Feb with the "stuck clutch" after power washing to repaint...
  4. W

    640 Oil Fluids

    I just drained the hydraulic fluid from the center drain plug. Will replace with the NH 341 oil. Tranny oil is next and then the rear drain plug which I think is rear end oil. Are the oil chambers connected to another? [Do they splash over into the next chamber?] I thought I was supposed...
  5. W

    Too Cool 2120

    Had chance to tractor for snow removal AGAIN ! I reved it up a little more up to near PTO speed and the temp gauge came up to operating temp and the cab heater blew heat out. The only thing I did to "fix" is remove the radiator cap. It seemed to come off normally, but could it the cause of...
  6. W

    Too Cool 2120

    Thanks for reply, but the fluid level is right up to the top in the radiator tank and also in the overflow bottle after it cools; also when it is hot the overflow tank shows full to the top line.
  7. W

    Too Cool 2120

    My 2120 with Jodale Perry cab ran cool last year. Put in 188 degree thermostat. Added cardboard to front of radiator. Got nice and warm and temp gauge showed "Normal" the past 2 months. Now, yesterday it only shows just above 'cold' on gauge and blows cool air in the cab. How do I get it up...
  8. W

    641 gets 'er done

    Looks like the previous owner took advantage of Fords offer of: "Free power wash and paint job with dealer service." In the early/mid 60's Ford (Henry) was still miffed with Ferguson and soon brought out the Ford Blue and probably wanted to show off the masses of Fords out there so the blue...
  9. W

    640 Clutch stuck

    I power washed my 640 to paint. Water must have gotten to clutch and rusted clutch plate tight. I drove round and round ,up hills with trailer, stabbing brakes and then parked for winter. If I remove the steering gear box, can I access the clutch to pry free? Splitting will scratch paint and...
  10. W

    Trailer Rotortiller

    The tines aren't that long; they aren't any longer than my 3.5 horse Gilson...
  11. W

    Trailer Rotortiller

    I thought that also. I have a 43 horse NH2120; but I plan to keep plowing in fall and would use it in spring instead of the little walk behind. I cannot take all that vibration the little ones send to my shoulders and back. Son-in-law has a deer food plot that we plow first so tilling should...
  12. W

    Trailer Rotortiller

    I also thought it was modified, but I cannot see that it had been an original 3 point. There is a top link attach point, but no lower attachment points visible unless they really did a neat grinding job. Other conversions I've seen it is obvious; I have an idea to add the lower 3 point pins...
  13. W

    Trailer Rotortiller

    I found this Trailer Rototiller about 30 miles south of Green Bay. Any information is appreciated as to Make, etc. The metal ID tag is broke off and there is remnants of orange paint. It is almost 7 feet till width. Was it made for 40+ hp tractors before there were 3 point hitches? I will...
  14. W

    Turf tires to R4 on front of 2120

    My front 27x8.5x15 turf tires[4 ply](26.6") are worn on my 1997 NH 2120 4x4; I am seeking advice if I could go to an R4 27x8.5x15[6 ply] (26.7") tire. I use the loader a lot and the turf tires really "squat down". I think the R4 is made to take more of a load [Heavier sidewalls and the obvious...
  15. W

    Adding remote valve on 2120

    My 'new' tractor is a 1997 New Holland 2120, 40 years younger than my 640 and 861. I am interested if an additional remote valve can be plumbed into the ports on the single remote valve body. I attached a picture showing the front plugged part (yellow arrow) and the side plugged port. Is one...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top