(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. S

    Need source for quality ignition parts

    Good day< Need source for quality ignition parts --especially the condenser for my TO35 Ferguson. Are brass contact distributer caps available?
  2. S

    No start when hot

    Ferguson TO 35 gasoline fueled Starts like a champ when engine cold but will not start when engine hot(worked). After it sits for a couple of hours it starts immediately. What's the problem?
  3. S

    What grease for mt rotary mower gearbox

    I wish to thank all those that responded to my question regarding what lubricant to use for a leaking rotary mower gearbox. It seems that J D Corn Head grease is the most recommended choice.
  4. S

    Wet tire gage question

    I wish to thank everyone that replied to my question....much appreciated
  5. S

    rotary motor gear box grease ?

    Gear box on my 3 point rotary mower leaks 140 gear oil. Any advice what type grease I can use that will stay put and will lubricate the gears ?
  6. S

    Tire gage for liquid filled tires ????

    Is there a tire gauge especially for liquid filled tractor tires ?
  7. S

    Ferg TO35 PTO oil seal

    When (trying to) remove PTO shaft oil seal how can I get out the boss that houses the seal? Forums say to screw on the PTO Cap and pull the boss out after taking the 4 bolts out. Problem is that I don""t have a PTO Cap. Any advice?
  8. S

    Briggs 'Vangard' no charge

    No charge. What is procedure for finding problem?
  9. S

    JD 1010 electrical polarity

    Is the electrical system on the JD 1010 positive(+) or negative(-) polarity? What's the procedure for reversing the polarity if it's incorrect? I think this one is not correct. Thanks.
  10. S

    1010 Spark plug gap

    Please supply correct spark plug gap for JD 1010 Gasolene engine. Thanks
  11. S

    BEWARE of faulty JD ign. point sets

    Neighbor just bought JD (genuine)ignition points for his 4cylinder JD (I don"t know the model). The stationary point base plate so wide it hit the cam so that NO gap could be set. He went back to JD dealer (32 mi. one way). Dealer agreed that the point set "improperly manufactured". Dealer will...
  12. S

    Carbon remover???

    Any suggestions regarding what chemical(spray or brush on) to use removing carbon from aluminum combustion chamber (head, piston, etc)The head is off.
  13. S

    Kohler K321 won't start

    Gents, Kohler K321. Over three or four months became harder and harder to start(cranks great). Replaced coil, plug,condenser, points. Started right up. Ran fair for a day then got very hard to start(again). Now won't start regardless of what I do. Checked points, checked and cleaned...
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top