(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. R

    Super M clutch slip (main or M&W)

    I had the first real test for my Super M project, and unfortunately it failed. I was mowing my field, and after a few passes it stopped moving when mowing up a hill of very thick grass. I turned off the mower and still it wouldn't move. I gave it about 40 seconds to rest and it went up the hill...
  2. R

    Water pump packing

    I have a bit of a leak on a Super M water pump at the tip. I guess the packing is not doing the job anymore. I was looking online and if I understand what I need, I see that a piece of packing is about $25 and you need 3 of them? Really, $75 to repair it? Is that right? Is there any cheaper...
  3. R

    M&W clutch removal

    I bought a SuperM that I've been repairing. It's going, but it's leaking oil out of the M&W hand clutch. I presume there is an O-ring that needs replacing? I took off the housing bolts but I can't get the housing off. Feels to be stuck around the handle shaft area. Is it threaded somehow and has...
  4. R

    Super M carb broken tube

    I took a look at the carb for my Super M project. When I took it apart I found the little tube that sticks out between the halves was slightly bent. Tried to see what was up with it and it quickly broke off. I did some searching and found some info for the Cub, and what they call the idle tube...
  5. R

    H magneto no spark after tune

    I'm in a bad luck streak. I hand crank my H and for a long time it's been a pain to start when warm. I've heard that could be the condenser, so finally I took the magneto off, replaced the condenser, put it back on. Now I get no spark. The tractor was running fine before this. The only thing is...
  6. R

    Super M transmission crack

    Wow, everything is falling apart now that I'm starting to put the tractor back together. The transmission input shaft isn't sliding into place very easily. As I was looking at why, I found a vertical crack in the transmission case between the countershaft and input shaft. How concerning should...
  7. R

    Super M transmission input needle bearing

    I was putting my transmission back together and sadly didn't quite have the main shaft lined up with the input shaft. As I tapped the input shaft in, you guessed it, I broke the needle bearing (arrrrrrrrrrrrrrrrrg!). I'm searching around but I'm not finding the part online. Anyone know the best...
  8. R

    Clutch throwout movement

    I bought a Super M that I've decided to rebuild. I have the engine separated now and looked at the clutch mechanism. The grease fitting for the throwout bearing goes off to the side, and I see that it is resting on the block (and not lined up with the hole to stick the grease gun into. The...
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top