(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. G

    Carb problems 55 super oliver

    New float new needle and seat tractor starts great idles and good throttle response smokes like choke partially on but not no change when adjusting low speed or high speed adjustment screws needle setting when carb turned upside down and blowing on inlet needle opening when upright and blowing...
  2. G

    Pto drum oil leak

    On transmission side of Pto drum 55 super there is two o rings shown in parts the larger is on outer ring of flange holding drum oil seal a smaller one goes on pto imput shaft but not sure where as mine was broken and fell out when removing drum so not sure whether goes before spline or after...
  3. G

    Case LA starter brushes

    Anybody know of a source for starter brushes for Autolite ML 4216 starter. Starter has got lazy bushings are good but brushes well worn so not getting enough spring pressure Thanks Paul
  4. G

    Hand crank location VA Case

    Anyone know the location engine hand crank was stored on VA Case tractor Any suggestions greatly appreciated Thanks Paul
  5. G

    VA Case wiring mounting for Lights

    I am currently re assembling a 1946 VA after painting and wiring the lights When I got this tractor 25 years ago only one light assembly mounted at outer edge of floor board brake side and no wiring light switch had a piece about 2” long attached to switch so wondering if someone could start...
  6. G

    LA Case starter

    Anyone know the spec # for Autolite starter I believe starts with MAB I need an armature for mine and of course the name tag is gone off mine. The tag on DC starter is MAB 4105 same size nose cone and bore size and length but starter body smaller diameter than the LA. Thanks for the help. Paul
  7. G

    Battery drain

    Have a D14 Allis-Chalmers battery dead installed new battery started tractor shut down went to start next day battery drained down Any suggestions where I could start to look for a drain lights definitely not left on Thanks for help Paul
  8. G

    Soldering starter contact bolt

    The field coil straps to contact bolt solder has let go what type of solder would you use to re attach Thanks Paul
  9. G

    Governor driven hydraulic pump

    Is the pump used on a John Deere 70 the same as on a John Deere AR governor driven
  10. G

    Size of oil hole covers in magneto

    Could someone tell me hole size diameter of oil hole flip caps on it magneto I?m not home for winter so not near magneto to measure found both 3/16 and 1/4 drive ins to replace mine with missing lids want to get right ones Thanks Paul
  11. G

    Super 55 steering

    55 super steering with front wheels off ground easy turn right but harder to turn left have backed off adjustments on each side of steering box no change have 4 to 5 inches free travel on steering wheel but no end play on steering shaft when lift in steering wheel changed spindles and bearings a...
  12. G

    How to prime hydraulic pump

    Have hydraulic pump just installed on 1950 John Deere ar governor drive higher than reservoir doesn t seem to want to suck up fluid any suggestions Thanks Paul
  13. G

    Prime hydraulic pump

    Have installed governor drive on 1950 AR what is good way to prime pump as doesn t seem to want to lift oil from reservoir Thanks for help Paul
  14. G

    LA Case Head

    I removed the head on my LA today to do some valve work and I find a hole in center of head 1.95" full of rust does this hole have a frost plug or is it open to the head gasket located between #2 and #3 cylinders Thanks for help Paul
  15. G

    R pup engine backfiring and stalling underload

    My pup engine when loaded for starting diesel requires playing with choke backfires stumbles stalls out choke brings back Curious what thoughts are on magneto points needing attention before I remove hood to get at magneto Thanks for thoughts Paul
  16. G

    Merry Christmas

    Merry Christmas to all who help out with answers and opinions to questions posted on this site you are truly great people best to you and yours Paul in Ontario
  17. G

    How to remove nose and grille on R

  18. G

    Leaking new needle valve marvel scheduler tsx 97 carb

    Replaced needle seat new float set at 1/4 inch still not shutting off flow totally have spring clip on needle to float any guesses what I missed Thanks for help Paul
  19. G

    MM ZB pulley free wheeling

    Picked up a Minnie from buddy today to get started for him put a flat belt on pulley to another tractor engaged hand clutch nothing happens pulley free wheels any suggestions before lift top off transmission to peak at inards Thanks Paul
  20. G

    LA Case positive ground

    This question has been asked before I’m sure I have a 1949 LA Case that has never had a battery since I bought twenty years ago has a good magneto starts with couple half revolutions on crank but I’m getting older not so easy to crank starting a restore and want lights to work so installed some...
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top