(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. V

    John Deere model 44 plow

    I started plowing at about 13 with a model 44 2 bottom plow. 50 years later, I got ahold of one and restored it. Plows fine. Problem is, when I take it on the road, it whips violently from side to side. I'm sur my Dad's didn't do that. Suggestions?
  2. V

    John Deere B Brake Reline

    I have my brake assemblies apart. '46 B. Have had the drums turned to clean up. Those engineers sure wanted to be sure the shaft and gear stayed tight with a tapered spline. The inside of the assemblies are just a bucket of rust. Were the parts originally painted? What color? I plan to...
  3. V

    46 B Rebuilt carb quits plowing

    Gentlemen, My tractor is a 46 B all fuel. I've had it for 25 years. Always, in the past has started and run fine. Any trouble, change plugs, points and condenser. Lately been having trouble fouling plugs. I have used Champion 502 for years. Finally bought a rebuilt DLTX72. Installed it...
  4. V

    John Deere A - What year??

    Can someone bracket the year for this John Deere A. Unstyled must be '38 or earlier, right? When did they go from the flat spokes to round spokes? The picture was taken in 1942 and the tractor looks pretty used. No paint. Thank you, Vince
  5. V

    Magneto Timing John Deere 1946 B

    My magneto has been mounted full clockwise for years. It began firing before TDC and kicking back while trying to start. Wonder what made it change. Bigger question: How get the magneto to mid-slot location without removing governor housing from tractor and remounting, so I can do magneto...
  6. V

    JD B running Rich

    Poppin John rebuilt my carb exactly 2 years ago. It?s from my John Deere 1946 B. It?s started and has run great until recently. I noticed it smoking a little while Bush-hogging the last few weeks. Also, it became finicky to start. Used to be 3/4 choke and started right away. Now, choke and...
  7. V

    Powr-Trol Conversion on to a Power Lift B Tractor

    I have a '46 B John Deere with the Power Lift. What does it take to replace my valve housing with one from a Powr-Trol tractor? More parts than those on the two units? Unbolt one and bolt on the other? Thank you, Vince.
  8. V

    John Deere B No Spark

    My tractor started stumbling. Points and rotor didn't look good. WICO C magneto. I installed new points, condenser, rotor and cap. Now, I have no spark at all. Double checked point gap. What could I have done wrong?
  9. V

    John Deere B 1946 stumbles under increased load

    My tractor stalled a while back and it wouldn't start. I put in new points, condenser and rotor. Then put a kit in carb. Now, it starts immediately, idles and runs smoothly. When bushogging, and hitting heavy grass, tractor stumbles with a little darker exhaust. Have gone up a little and...
  10. V

    46 JD B axle re-assembly problem

    I replaced tapered roller bearings and seals on both rear axles. Tightening the nuts draws each axle in to 3/8 inch of being seated. Hits a brick wall. Even with a piece of pipe on the wrench, I can't draw either axle in further. Did I install something wrong? Have pictures I could email...
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top