(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. D

    MF 470 Wheel Loader

    We have a MF 470 wheel loader- riged frame, single center arm, Continental 6 cyl in line gas engine. Think it is the same as a Michigan Wheel loader? See link for a similar unit that sold at an auction last year. Need a bendix spring. Only marking I have is the starter is a delco remy 1107851...
  2. D

    AC Mfg Co. company safety shoe store pullman sleeper

    This may be better suited to the other AC form. There is a photo of the AC MFG Co safety shoe store care here. http://ingenweb.org/inlaporte/lpcityphotos.htm Im reasonably sure thats a surplus Pullman troop sleeper. What Im wondering, is was it kept pullman green? Im thinking the...
  3. D

    Ford 801 D cable through hood-how to remove handle

    Working on neighbors Ford 801 D. Missed placed our shop manual for that model. So whale ordering another, trying to get hood off. There's a cable that goes to the transmission (not the Select o Speed) need to take off handle. Seams there is a set screw, assume it's just that not actually...
  4. D

    Ford NH 1715 no hi range, weak middle

    Got a Ford NH 1715, cant even pull itself in hi range, not the best on middle, ok in low, bought that way. Any recommendations on what to check or what might be wrong?
  5. D

    MF 205-4

    I posted about a neighbors 205-4 being hard to steer. Took apart left front today-bearigns are shot. Particularly 3281457M1, should have 105 balls, lucky if we have 5. Am I correct, 3281457M1 is stupid expensive, only one I see is $425?
  6. D

    MF 135 3 cyl perkins lost prime plenty of gas

    Haven't gotten back to the 205 yet. Ended up with a different neighbors MF 135 with 3cyl Perkins. When, started ran, then it died. Had 7 gallons of fuel in it. Only way we got it going again was to blead the lines per the book-starting at the lift pump to the filter, then the injector pump to...
  7. D

    Massey 205 4wd hard to steer

    neighbors Massy 205, Sn #1, 4wd is a bear to steer. Has no power steering. Has a loader, took loader off makes no difference. Could the bearings be going out causing it to be hard to steer?
  8. D

    What do you call this vehicle?

    What do you call this vehicle? Yard Cart? Mule? ? Made by Kawasaki.
  9. D

    ECHO Chain saw won't rev up

    Neighbors ECHO 87G1, had bad primer bulb. Put in new universal kit one form TSC. Can get to run, but start it at idle, won't rev up. Start it in high, it will run. Has good fuel and air filters. Any one had similar issue with chainsaw?
  10. D

    JD UVGX 620 gator ran out of gas now not running well

    Neighbor has a JD UVGY620 gator, gasoline. Info we got, was they ran it out of gas and added more and it wouldn't run, they changed a spark plug (they didn't know it had 2) and limped it home. I don't know how long ago that was Today when dad brought it home, he ended up changing the plugs and...
  11. D

    Allis G distributer whoes

    We have two Allis G’s, but this week Dad has had issues with what I’ll call #1. Drove it out of barn on Sat, and by Monday it wouldn’t run. After a through process of elimination, swapping parts between #1 & #2, only way he got #1 to run was with the distributor from #2. BUT #2 will run...
  12. D

    IHC C1 Truck unknown rear end

    I’ll place this here since it’s not 100% IHC, but the folks here on yt tend to know quite a bit besides just tractors. We have a 1936 IHC C1 truck. Appears we don’t have the original rear axel-there’s no opportunity for the emergency break. Dad thinks that may make the axel out of a Dodge...
  13. D

    Wards Twin Row

    This message is a reply to an archived post by Tom RS on June 19, 2020 at 07:57:07. The original subject was "Wards Twin Row". Finally found photos. My dad sold one a couple of years ago, also a 42. All I have for a SN photo is one, looks to me like might have been black letters. You didn’t...
  14. D

    Toro Dingo 320D engine

    My Dad has a Toro Dino 320 D with a Kubota D600 3 cyl diesel in it (not the original to the 320D). About less than 10 years ago, he had the injector pump rebuilt on it when he brought the engine back to life from the weeds. Some time later, it started acting up, where it will die, but it will...
  15. D

    Ford 3400 injector line seal?

    Are there supposed to be seals on the injector lines on the ford 3400 D? parts diagram don't look like it, but the lines are leaking at fittings on neighbors tractor.
  16. D

    Ford 801 valves

    Not sure exactly how long ago, my dad put at least new rings in neighbors 801 4cyl gas. May have touched up valves, we don?t recall. Anyways, put back together and it ran ok and sent home. Last week he brought it back only running on two cylinders-pulled plugs, compression gage, no...
  17. D

    Case Manure Spreader

    Hello, My dad has recently acquired a case manure spreader. It works, but he said in his opinion the chain ran too fast. Wouldn?t mind getting an OM but don?t know the model. Only numbers I find is a very faded W007. Trying to post photos, first from my phone, I usually use the computer on...
  18. D

    WD45 oil pump screen

    Trying to get a WD45 motor that had sat with the oil pan off for some time prior to us buying it. Looking at the oil pump screen its not in the best shape, couple of tares in it. Ive yet to see it listed here or on a couple of the other parts sites-dose anyone offer a replacement for the screen...
  19. D

    Toro dingo Kubota diesel Dies restarts

    Have a Toro Dingo, with a 3 cyl Kubota diesel. It will run, but often will die, almost like its out of fuel, but then it will start back up no problem, but is liable to die again. Seams worst in cooler temps (phx area, so not below freezing) or with a cold engine. At all throttle levels it is...
  20. D

    1952 8N Bendix

    My Dad's working on a 1952 8N. He was trying to get it started, it backfired, then starter wouldn't work- pulled starter- Bendix has parts missing/broken off. So I've ordered him a new Bendix. He hasn't yet tried to see if he can make it turn over by other means; provided it will turnover...
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top