(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. P

    Massey 65 starting issue

    I have a 65 with the Continental G176 gas engine. Switched to electoral ignition over two years ago. Have had no issues, starting, running, nothing. Till 2 weeks ago, while moving round bales, it started running rough, like a slight misfire. Then it died. Couldn't get it to kick over...
  2. P

    Ignition problems

    Here I go again...I will repeat myself and tell you that I have very limited knowledge of mechanics and engines, but I've got a 58 MF65 gas that's got a generator, and has been covered to an electronic ignition. We have replacedall the wires on the ignition side of this tractor...
  3. P

    Safety switch..

    Ok guys, I'm very limited on tractor knowledge, but with reading these forums , I'm learning more and more, thanks for that. I've got a 1958 mf65 gas, converted to electronic ignition and alternator. I believed I'm having problems with the neutral safety switch, as sometimes when ignition...
  4. P

    Hydraulic fittings

    I ordered a new set of loader bucket cylinders. Ports are listed as 1/2 NPT. I picked up new hydrailic 1/2 Male pipe thread to 1/2 female pipe thread 90 fittings for those ports. I have pipe dope or tape both. My question is, as I'm trying to screw these fittings into the ports, I'm meeting...
  5. P

    Hydraulic help.

    Ok, I'm a newbie, so excuse my ignorance. I have a 1958 MF65 gas with a Bush Hog 2400qt loader. The guy I bought this setup from told me to not use the loader hydraulics when you're using the rear hydraulics. No explanation other than that's what his Dad always said. I'm assuming...
  6. P

    65 water temp.

    I've purchased a 65 gas a couple of weeks ago. Gauges didn't work, Just changed alll dash gauges. Started engine, let it idle for about 15 minutes. All other gauges work, but noticed that even after 15 minutes, water temp gauge still showed cold. Shouldn't that time be enough to show...
  7. P

    65 transmission fluid cap

    I could use some help. Bought a MF65 not too long ago . Been using it, then noticed one of the loader bucket cyclinders was leaking fluid pretty rapidly. . Had both rebuilt, no issues. Now I need to fill up the hydraulic / transmission hold. Previous owners have mangled any flats that...
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top