(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. F

    TO-35 input seal

    Gents I need to replace the input seal for the transmition in my 1960 TO-35. The manual clearly states that one needs to remove the pto live shaft brg housing, a snap ring, and pull the shaft out to let the drive gear fall down so that the input shaft housing can be removed. I am to this point...
  2. F

    TO-35 video

    Hello gents. I have not stoped by in a while hope all is well. Here is a short video of my TO-35 plowing with my Ferguson one bottom roll over :) . http://www.youtube.com/watch?v=rzeLqiVKhKc
  3. F

    TO-35 governer ???

    On the 35 i just looked at there was a spring holding the governer arm back(not a factory piece). If removed the engine would rev way to high, so I am sure the governer would need work. my ? is how much of the tractor needs to be taken apart to get at the governer. I looked in the archives and...
  4. F

    '55 TO-35 clutch ???

    I recently looked at a TO-35 that someone had partialy restored. The serial# reads "TO-35 141405" I was unable to detrmine if it has the dual clutch. It does not have power stearing, appers to have had a tractormeter but it is gone. The clutch is damaged so I was unable to check it by depressing...
  5. F

    TO-35 Hyd. pressure test

    I would like to temporarly install a pressure guage on my 35 to check hydraulic pressure. What is the best location(on the tractor) to do this at?
  6. F

    TO-35 duals

    In the owners manual for my To-35 it says that there was a dual rear wheel kit available. Has anyone had one with duals? Does anyone have pictures?
  7. F

    Ferguson sycle bar mower

    I have found an old Ferguson bar mower. It is all there but in pretty rough shape. I need some insight on $$ value, and parts avalibility. Thanks!!
  8. F

    Hauling brush with my TO-35

    A nice weekend
  9. F

    TO-35 value $$

    Looking for some opinions. What is the $ value of a 1960 TO-35 deluxe,running, Hi-Lo transmition, originaly power stearing, but now missing PS pump. Needs front axle bushing, front tires shot, rear tires one OK one shot, power adjust rear wheels. Body parts straight, but all surface rusted...
  10. F

    I dreamed of Africa

    I recently watched the movie "I Dreamed Of Africa" in which the character "Kuki" attempts to build a dam with a small crawler tractor. As best as I can tell the little crawler has a Ferguson badge on the front. Was there ever a Ferguson crawler produced on a TO or TE model? Or was there some...
  11. F

    TO-35 stumbling

    My TO-35 will stumble and sometimes die when it is cold out. Say below 30f. It starts, idles, and runs fine, but when I let the clutch out to start it wants to die. It will lug fine if I get past this point. It does not do this in warm weather. It has new plugs and wires. Any sugestions? Thanks!
  12. F

    TO-35 hydraulics (oil foaming)

    I am using a 90w oil in the trans-hydraulic system on my TO-35(as recomended in my YT manual). As the oil gets more use it starts to get a foamy look to it, and I lose a lot of lift capacity at my 3-point. Has anone else had this problem. Any good fixes? My dad has an 8-N ford and does not have...
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top