(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. D

    setting valves 46 c

    reassembled cylinder head can i set the valves cold to get it started if so what gap? their suppose to be set hot at .010 correct? any tips on procedure the rest of motor is assembled.
  2. D

    cylinder head 42b

    replacing head after valve job, looking for info on torque spec, valve clearance (cold) after assembly to start with. also any tips on how or best way to set them.
  3. D

    recondition john deer cyclinder head

    looking for some one in the twin citys metro area in Mn. who works on old jd tractors I have a 42B that I would the cylinder head looked at.
  4. D

    water/oil

    my 42 john deer after sitting for awhile I end up with water in the oil not a whole lot tried new head gasket still have water replace head next?
  5. D

    oil filter replacement 42b

    any sugestion on an oil filter that i can get from an auto store or simular place? i usely just order them from a JD dealer hoping to find cheaper thanks for all the replies
  6. D

    tappet ajustment on 42b

    i know that they should be set at .020 my question is should they be set hot or cold one manual says cold the other says hot? if they need to be set hot, what should i put them at after assembly
  7. D

    new head gasket

    replacing head gasket on 42b what are opinions on useing some silicone gasket goo or not to goo on surfaces along with gasket?
  8. D

    cylinder head question 42B

    is their away to check for cracks in the head or cylinder walls other than visual? had antifreeze in oil pulled off head looked over both surfaces and gasket and where ever else i could see,nothing was obvious.
  9. D

    water in my engine oil

    its a 42 B
  10. D

    water in my engine oil

    42 john deer went to change oil have antifreeze in my oil thinking a crack or something in cyclinder head any thoughts
  11. D

    brake band removal on C

    have a 46 C any tips on removal of brake band, pivot an anchor pins thanks
  12. D

    best alternator to use

    i do like that idea can i use the same light switch/charge or do i need something else
  13. D

    best alternator to use

    thinking about converting to twelve volt on my C is their one style or off a vehicle most prefer to use which would fit the best
  14. D

    Allis Chalmers B, C, or CA

    check flyingsfarms New Berlin IL
  15. D

    gas tank for a 46 c

    need gas tank any one have know of a place wher i can get a good one
  16. D

    46 C its alive

    thanks for all the info, first time complete rebuild, motor sounds great.
  17. D

    remanufactured gas tank

    is their a place i could get a new or a remanufactured gas tank for my C ? running out of JB weld
  18. D

    light switch

    good call on rusted shaft works fine now
  19. D

    light switch

    the three position switch on my C is shot (will not move when force is applied) would an auto parts store carry the same switch if asked for a three position light switch like the one i need
  20. D

    ignition positive ground hook up

    new to positive ground could use some help on my C how do you wire the ignition circut? tractor has coil & distributor any other wireing info on the rest of it apprecated almost done thanks
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top