Search results

  1. D

    Limiter Chains on 2N

    Trying to figure out where to connect limiter chains on my 2N for the brush hog. Any suggestions appreciated.
  2. D

    Dearborn Cultivator I.D. Tag.

    Could someone provide a picture of the Dearborn Model 13-2 cultivator metal tag? I need to replace one and would like to see a picture of original tag.
  3. D

    Ford 309 planter plates interchange

    Will the seed plates from the Ford 309 planter interchange with the Bridger Row Runner planter?
  4. D

    Food Plot Planter

    Anyone know anything about these Bridger Row Runner planters? Picked this one up today for planting food plots. Looks to be well built. Wondering about obtaining different plates for it especially sunflower plates. Right now all I have is the corn plate. Could this plate also be used for beans?
  5. D

    Superior Loader Hydraulic Control

    I have a Superior loader mounted on a 64 Ford 2000. The hydraulic controls are very quick to respond. Is there some way to slow them down to smooth the response. It is very hard to lift anything slowly.
  6. D

    MF GC2300 Garden Tractor

    Can someone tell me where to check the oil level on the front and rear differentials? I am trying to service my daughters Massey-Ferguson GC2300 tractor and found the fill plugs but unable to locate the oil level check plugs. This tractor is new to me I am used to working on 60 and 70 year old...
  7. D

    MF GC2300 Differentials

    Can someone tell me where to check the oil level on the front and rear differentials? I am trying to service my daughters Massey-Ferguson GC2300 tractor and found the fill plugs but unable to locate the oil level check plugs. This tractor is new to me I am used to working on 60 and 70 year old...
  8. D

    Follow-up on 2000 Engine Backfire and Die

    When I asked this question on the board I got some very helpful suggestions. Found the problem to be the points and condenser. Engine now runs great. Thanks to all for your help.
  9. D

    1964 Ford 2000 backfire then shuts down.

    Engine was running rough but today I went to start it and it was backfiring real bad then it died and will not start. Pulled the plug on the bottom of carb and getting plenty of gas. Where to start on the electrical part?
  10. D

    Spark Plugs.

    What is the recommended spark plug for a 1964 Ford 2000 with a 134 engine?
  11. D

    ATF in POwer Steering

    Is it OK to use ATF in the power steering reservoir of a 64 Ford 2000?
  12. D

    Draw on Battery. 64 Ford 2000

    What would cause an overnight drawdown on my battery to be completely dead. The battery checks out good and the switch was not left on? Any help appreciated.
  13. D

    8N RPM Problem

    Have a 1950 8N side mount distributor Ford tractor that when I increase the lever on the throttle quadrant one notch it goes from 500 RPM to 1300 RPM. The linage from the govenor to the carb barely moves when this takes place. Any help here would be appreciated.
  14. D

    Rest-O-Ride Rebuild

    I just finished these two Rest-O-Ride seats. The one on the left was done with parts I had acquired over the years from dis-assembled ROR seats. The one on the right has new bushings and a new adjusting bolt. I have done several of these seats over the years and the hardest part for me is...
  15. D

    Late 9N Ford

    Tried to bring this one back to as close to original as I could. Switched from 12V back to 6V. New brakes and sure-seals. New wiring Still has the 32 inch rims and tires on the rear. Used the sunflower patch for a back drop. We planted these for the song birds and especially the Goldfinch, It...
  16. D

    1950 8N Electrical Question.

    First time replacing points on side mount distributor and I got no spark after setting new points at .025. I have spark to the coil. I also replaced the condenser and rotor. Should I see spark as the points open and close with the distributor cap off and turning engine over with the ignition on?
  17. D

    Jubilee clutch will not release.

    Got a problem with my Jubilee. The clutch does not dis-engage sometimes in reverse unless I hit the brake, then it will release. It does not do this in any of the other gears. Does anyone know what my problem could be?
  18. D

    Hat Rim Bolts

    I have been trying to remove the bolts from the rim. I soaked them with PB Blaster for two days, have tried the air impact gun and also a large maul and have only been able to remove one of them. Is there anything else I can try before I remove the tire and tube and use the torch on them. Any...
  19. D

    '41' Grill

    I am working on a very late production 9N, serial number 9N 98991 which was made in early 1942. Would the 41 grill still be correct for this tractor? I have several of these grills and would like to use one on this tractor.
  20. D

    Erratic Reading on Amp Gauge.

    I just replaced a non-working Amp gauge with a new one and now I get very erratic readings. It will not charge at all unless I tap on it and then it will show about 10 amps charging and start bouncing the needle and then nothing until I tap it again and it does the same thing, charge for a few...

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top