(800) 853-2651
SHOP NOW

Search results

  1. A

    Tractor Seat Recommendation

  2. A

    Tractor Seat Recommendation

    Thanks Dennis. Found one to my liking from the link you sent.
  3. A

    Tractor Seat Recommendation

    Thanks for the replies. Have a couple of other options now. I also discovered the component part numbers on AGCO and see where they are sold aftermarket. Now to decide.
  4. A

    Tractor Seat Recommendation

    Looking for a good tractor seat. The ones we have bought for our MF35, MF250, MF265, JD1530 all do the same thing. The bottom of the seat begins to tilt forward to where you are sliding into the steering wheel. Just about impossible to drive if you have a belly. These tractors get used right...
  5. A

    MF265 Auxiliary Pump Replacement Part

    Thanks for the reply James! I did finish the install about 2 weeks ago. It was a good experience. This is my 4 split (8N, MF35 (three times!) and the 265, so I am getting a little more comfortable with it. I did splurge and get the Sparex splitting stands. It made a difference on the last...
  6. A

    MF265 Auxiliary Pump Replacement Part

    I was able to turn the shaft a little with a pair of pliers, but only enough for it to move. As far as the tightness of the shaft I was told this is normal. They also said it would not hurt to put a little oil in the pump and turn the shaft with a pair of vice grip pliers to pre-oil the pump...
  7. A

    MF265 Auxiliary Pump Replacement Part

    Have another question regarding the new replacement Auxiliary Pump. I started moving some of the old parts/fittings over to the new pump and noticed I cannot turn the shaft on the new pump. It's locked tighter than a tick whereas the old one I can easily turn it and hear the sucking sounds...
  8. A

    MF40 Industrial won’t start after 12 years

    2nd
  9. A

    MF40 Industrial won’t start after 12 years

    I wonder if it's possible to initially use that temporary tank just to see if it will crank. Never thought of that. If it does, then there you go.
  10. A

    MF40 Industrial won’t start after 12 years

    I am not sure what kind of access to the shutoff valve there is on the MF40 compared with the MF35, but on the 35 I just drained the fuel from the tank at the manual pump, removed the lines from the shutoff valve, and unscrewed the valve from the bottom of the tank. If you could rig something...
  11. A

    MF40 Industrial won’t start after 12 years

    Did you ever check the fuel shutoff valve filter at the tank? After sitting 12 years there may be trash/sludge buildup.
  12. A

    MF265 Auxiliary Pump Replacement Part

    I will be replacing the Auxiliary Pump 1663627M92 on an MF265 and see where all the replacements come with a Restrictor or Pressure Relief Valve. I hope I am using the correct term. Mine does not, but I am guessing this will work. Are there any adjustments that need to be taken into...
  13. A

    MF 265 Replacing Tube from Auxiliary Pump to PTO Cover

    It looks like it will from the bench. I was able to split the tractor today. Once I look over and repair/replace auxiliary pump will start putting everything back together.
  14. A

    MF 265 Replacing Tube from Auxiliary Pump to PTO Cover

    I received fitting 1684488M1 and the other parts to work with the PTO cover. Thanks Wayne!
  15. A

    Massey Ferguson 265 Split

    Thanks. Looking at screenshot 141102.. above, I performed steps 1 - ... a - Check b - Check c - Multi-Power not equipped d - Not Applicable e - Missed this step f - Check. g - Used Engine lift to lift and hold h - Check I may have been hampered by the fuel and radiator caps. The procedure...
  16. A

    Massey Ferguson 265 Split

    I present the mystery pipe/line. As far as removing the shift cover, it was not as straight forward as the two manuals I have. I opted for the lesser involved steps, but do not feel I did it right. It's going to be a pain getting that shift cover back on as I was barely able to get the cover...
  17. A

    MF40 Industrial won’t start after 12 years

    This is a little drastic, but you can try to give it a shot or two of ether while cranking. Hopefully it will eventually crank and work out whatever ails it. If it cuts off or fails to crank back up, then there is still a problem somewhere. A clogged in-tank filter on the shutoff valve can...
  18. A

    MF 265 Replacing Tube from Auxiliary Pump to PTO Cover

    Thanks Wayne. I was able to reach the local Agco parts dealer and I hope he is sending those as well. I have asked him to email me the parts list, but yet to receive it, but remembering in the conversation he did mention the names. He is also including a seal for the connection on the outside...
  19. A

    MF 35 troubles

    One more thing. You can check the fuel valve in the tank. It’s supposed to have a filter on it. During the take down on my 35 mine looked like this. Also the fuel injection pump had marks on it for timing. If it was ever loosened it may be out of time.
  20. A

    Massey Ferguson 265 Split

    Yep. It’s the banjo bolt.
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top