(800) 853-2651
SHOP NOW

Search results

  1. D

    Transfer Pump For Diesel Fuel

    I need a 12 volt transfer pump for a 100 gallon transfer tank. I will probably only run about 300 gallons of diesel fuel through it a year and I would like to add a filter to the fill hose where it hooks to the pump. I want 12 volt so I can just hook it to the tractor when fueling or my pickup...
  2. D

    Lewis Poultry Housekeeper

    I seen the picture that Destroked had with his Ford 4000 with the machine hooked to it. I haven't been around big poultry operations since the early 70's when I delivered bulk feed to a few that use to be in my neck of the woods in Mi. Never seen anything like what he had hooked to his 4000...
  3. D

    Quick Delivery Service

    I order a item on Amazon, I'm a Prime Member, yesterday at 2 pm. It was discounted if I ordered it between 2-7 pm. They even said I would get it by 10pm last night and I thought ya right on the so called busiest on line shopping day of the year. I left the house after ordering it and walked back...
  4. D

    Fair Price For Labor

    A friend from my church does some mechanic work on the side, his real job is a mechanic for the county. I took my Farmall C over to his house and he split it for me and pulled the clutch and flywheel out. I took the flywheel in to a machine shop and paid them to rework it and had a new ring...
  5. D

    Too Much Oil

    I changed the oil in my M6060 Kubota. It called for 12.7 quarts. So I'm must of been having a senior moment and was thinking two quarts to the gallon. Using bulk oil I put 6 gallon containers in the engine. Then started it until it reach oil pressure, probably about 2 minutes. Shut it off and...
  6. D

    How Much Corn Will My Trailer Hold OT

    I brought a dump trail that has a 12 ft long box that is 6 Ft wide and 42inch sides on it. I was trying to figure out how much 56lb per bushel shelled corn it would hold. I currently use a gravity box I mounted on a flat bed trailer that holds about a 120 bu or about 6500 lbs. This looks like it...
  7. D

    Hauling Cattle with Horns

    The guy down the road asked me to haul a couple of animals to the slaughter house for him. About a 40 mile trip. I have a 16ft. Corn Pro steel trailer that I take good care of and is still like new. When hauling a couple of market animals I normally put one in the front and one in the rear with...
  8. D

    New Holland Workmaster

    I'm looking pretty hard at a used, low hour, Workmaster 45 with 4 wheel drive. I see some used ones on-line within 500 miles of me that seem pretty reasonably priced. The description of the tractor seems to fit about what I'm looking for. Not allot of bells and whistles but a good no nonsense...
  9. D

    Tier3 and Tier 4 engines

    Does anybody understand the pro's and con's of these? Nearest I can figure the 4 has a little more emissions on it than the 3. I'm thinking replacing an older tractor with a new 40-50 hp. tractor. I know some dealers have some new 3 tier tractors left that they claim will be better than the...
  10. D

    3 Point Ball on my 231

    I lost the round ball on the end of a 3 point arm. The ball that is attached to your implement when using the 3 pt. I purchased a two pack yesterday with new clips. I installed the new one with a new clip. Good thing I got the two pack. When I got done disking stalks today, with a transport...
  11. D

    Electrical Wire Nuts

    When using wire nuts do you twist the wires together then put the wire nut on? Or do you just place them side by side and screw the wire nut on? Do you need tape the nut to the wire when done? I use to twist the wires together and tape the nut when done. I was recently told its better to not...
  12. D

    Kubota Experts

    My B3000 loader tractor just plain quit today. It acted like it does when you let up on the seat and that stupid safety switch cuts the motor. When you turn the key on everything works but it won't crank over. I stuck a screw driver on the starter and it will then crank but not start. I checked...
  13. D

    Marvel Mystery OIl

    I was thinking of adding some to the gas on my Farmall C. I don't use it much and I think it needs a good workout. I see where some of you recommend adding some to your gas. I thought I would do so before giving her a little workout. My question is, how much of the oil do I add to the gas? Thank...
  14. D

    Corn Head Grease Experiment

    As I checked the gear box on my old JD 400 grinder mixer today I decided to do a little experiment. I took the last dab of CHI corn head grease out of the grease gun and put it in the bottom of a cup. I added a little of my Advance Auto 80-90 wt gear lube to it. The lube ran right off the grease...
  15. D

    Ant Hills

    What's the best way to get rid of a couple of ant hills I have around my barn? I tried to goggle it but just seemed to get the run around. About all I came up with is to dump hot water on them until they go away.
  16. D

    Hydraulic Cylinder Capicity

    I'm looking at ordering a new cylinder for my 8 Ft. I.H. transport disk from ASC. The one I'm looking at has a 1 1/16 rod. with an 8 inch lift. Retracted length of 20 inches 2500 psi. My question is, is it big enough to lift the disk up and down without blowing the seal or something else. The...
  17. D

    Re: John Deere corn head grease....where?

    I buy it at my I-H dealer.
  18. D

    O/T Corn Pro Livestock Trailers

    I put a deposit on a 16 ft. bumper pull today. The dealer had a Calico in stock for $500.00 less. They were out of the Corn Pro but will have one in next week. So I put a deposit on the Corn Pro with the understanding that I could take a Calico if I decided the C.P. trailer wasn't worth the...
  19. D

    Propane or Natural Gas? OT

    The gas company finally decided to run a line by my house. They want 4,000 bucks to connect and 550 to run a line to a meter on my house. They are telling me that for every thousand I spend on propane I could get the same out of nat. gas for about 700 bucks. I would also have to replace my hot...
  20. D

    Grease Joint Rejuvenator

    I was looking at one yesterday at TSC for 49 bucks. It was made by Innovative Products in the USA no less. It looked like you put some penetrating oil or something similar in it, put it over the zerk and hit it with a hammer. It appears to open the froze grease zerk up. Looks like it could be...
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top