I have belt driven generator that I rigged up to run off
the mower deck pulley of a JD lawn tractor. I was
thinking about designing a way to run this generator
off the 9 in . diam belt pulley of an SC. I suppose a v belt
would just run on the flat part of the pulley if tight
enough. However
would there be a way to attach a v belt
pulley to the belt pulley?
Dont really want to weld lets say a 10 in. pulley and
cant go smaller since it is hollow .you know what I
mean.
I offer this up for any suggestions. Thx in
advance.
2900 watt 120/240 volt gen works good on my JD x590 and also
only Cub cadet 108
the mower deck pulley of a JD lawn tractor. I was
thinking about designing a way to run this generator
off the 9 in . diam belt pulley of an SC. I suppose a v belt
would just run on the flat part of the pulley if tight
enough. However
would there be a way to attach a v belt
pulley to the belt pulley?
Dont really want to weld lets say a 10 in. pulley and
cant go smaller since it is hollow .you know what I
mean.
I offer this up for any suggestions. Thx in
advance.
2900 watt 120/240 volt gen works good on my JD x590 and also
only Cub cadet 108