lee little
Member
It has been an interesting summer! The miles on me and my equipment seem to be catching up to me. I finally had a little time to get back to trying to put the pto drive shaft back in my 1850 diesel. I have loosened both front and rear engine mounts and alternative raised it on each end to change geometry at the rear but no luck! My thinking was that if raising either end let the shaft slide in I could shim that end. I am at a loss as what to do next. I had hoped to have it finished before Rrlund came down for the 127 yard sale but it don't look like I will. I guess he will see what kind of an incompent redneck I really am lol. Anyway I need help fellas. I have both aftermarket and factory manuals for it and they say very little on this subject. I hope someone here can tell me what I am doing wrong. Thanks for any help/suggestions you may have. Lee