1967 806 - no hydraulics

Anonymous-0

Well-known Member
I recently acquired one of my dad"s old tractors (a 1967 806D). I"ve got it cranked and running but it has no hydraulics. No brakes, steering, or PTO for sure. Have not hooked an implement to it to see if remotes are working but they don"t appear to be. Tractor has set up for at least 3 years. I was told all of the steering, brakes, and hydraulics went out prior to previous owners parking it. They said they changed the hydraulic filter and fluid in an attempt to fix it but could not get any of these areas to work. I spoke to the guy who worked for them and he said he changed an internal filter on the right side under the platform and the fluid. Any help wouold be appreciated.
 
1. got any hyd oil in it?
2. IPTO drive shaft lost its splines? all hyd functions including PTO are driven off that pressure plate spline. that one means a front split to fix. if you think that"s the problem and want to make sure before splitting, drain the hyd oil and pull the bottom cover of the speed trans (where the trans brake goes). then you should be able to look up and see the IPTO driven gear and see if it turns freely without the engine turning. or, have someone bump the starter and see if the gear turns.
3. if the pto works but none of the other hyd functions, there"s all kinds of things it could be.
 
PTO, steering, brakes, and 3 pt. lift do not work at all. Hydraulic fluid is clean, filter under platform is new and fluid level is good.
 

split the tractor and start replacing had to do mine two years ago . It went south one day grinding feed. I knew mine was going along with the center of the clutch disc and i just waited for everything to quite at once and it did . Took longer to take the flywheel to the machine shop and have it ground then the whole job took. Ya need a clutch , pressure plate , pilot bearing a throw out bearing a idpto bearing and seals and a idpto shaft. Nothing that money will not fix. Also get the flywheel refaced.
 
Thanks, tractor was in a field when i got ownership. With no steering or brakes,I have not been able to move it. Will have to figure out how to split it.
 
If you've got equipment big enough to deal with splitting it in the field, you've got equipment big enough to drag it into a shop where the job will go much easier...

There is no way you'll be able to split it by hand in the field. Something will sink or shift in the soft ground and you'll never get it lined back up.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top