2000/3000 drawbar

[Kirk-NJ]

Does the post ‘65 2000 have the same holes spacing under the tractor for a drawbar as the earlier pre ‘65 hundred series tractors . A photo might help

 

[Sean in PA]

I've never compared them in person, but looking at the parts drawings, I don't believe so. Plus, the pre-1965 4 cylinder models used a vertical piece that bolted on around the PTO shaft as part of the support for the drawbar.

Link to parts drawing for pre-1965 2000 swinging drawbar assembly

Link to parts drawing for 1965+ 2000 swinging drawbar assembly

 

[Fordfarmer]

Does the post ‘65 2000 have the same holes spacing under the tractor for a drawbar as the earlier pre ‘65 hundred series tractors . A photo might help

No. '65 up has 6 bolts underneath vs. 4 for the pre-'65 models. Different spacing, as well.

 

[Mike(NEOhio)]

I'd say probably not. I bought a set of stabilizer from TSC that were for a Ford. They were way too long for my '72 so the proportions are different from the pre-65s.

 

[Ultradog MN]

Does the post ‘65 2000 have the same holes spacing under the tractor for a drawbar as the earlier pre ‘65 hundred series tractors . A photo might help

Kirk,
I don't know the Hundreds that well.
The link below goes to an old post with photos of the drawbar hangers for a 2/3000 and 4000 - all 3 cylinder models.
These are similar to each other but the 4000 one is huskier.
They are both 1 piece.

Post in thread 'bracket ID ???'

Jun 16, 2019

Drawbar bracket off of a 2/3000.
Won't fit a 4000 as they are heavier.
Worth $40, maybe more on ebay.

• Ultradog MN