'46 2N with postion control, took the top plate and pump from a 48 8N and made the swap. The 8N was formerly a backhoe and is now a parts tractor, the 2N has been is the family since new, undergoing a "rejuvanation", not really a restoration cause i do plan to use it, as well as take it to a few antique farm equipment shows, figured the hydraulic "upgrade" would be a nice touch, never seen anyone else try it. One note, if anyone else does this, theres a small piece of casting on the right side (internally) that has to be removed, on the 8N you can see where they cut it out for the linkage to clear. I am painting it the correct dark grey once it warms up again.