Ultradog MN
Well-known Member
- Location
- Twin Cities
These last two 3000s that I bought were very early models and both had the lift arms with convertable cat I/II balls.
Kenny kept one set for his 3600 and I kept the other. Am going to clean these up and put them on my 3000.
This set is in particularly good shape - not much wear where the balls fit in and they even still have the little clips on them for storing the linch pins.
Were these lift arms common? I had never seen a set like this on a 3000 before.
They are the same length as regular ones but a little bit heavier
PS,
As I was about to post this I noticed the clips are on in opposite directions so I went out and looked at them. They both look like they are still held on by the original spot welds.
I wonder if whoever built them was hung over that morning and installed one backwards.
Kenny kept one set for his 3600 and I kept the other. Am going to clean these up and put them on my 3000.
This set is in particularly good shape - not much wear where the balls fit in and they even still have the little clips on them for storing the linch pins.
Were these lift arms common? I had never seen a set like this on a 3000 before.
They are the same length as regular ones but a little bit heavier
PS,
As I was about to post this I noticed the clips are on in opposite directions so I went out and looked at them. They both look like they are still held on by the original spot welds.
I wonder if whoever built them was hung over that morning and installed one backwards.