3020 3pt seals

[Ranhil]

I am wondering if anyone knows where I can get a set of seals for the bottom shaft that hooks the 3pt arms to the bottom of the tractor? A neighbor said he found some heavy duty ones for his online. He could not remember where he got them, but said they are much better than the ones you get from JD. I put new rubber ones in last summer, had the shaft checked (it is fine).

thanks in advance

 

[Anonymous-0]

I HAVE REPLACED MANY OF THESE GO TO JD AND GET THE SEALS AND BUSHINGS WITH THE O-RINGS, MAKE SURE YOUR SHAFT IS IN REAL GOOD SHAPE. PUT IT BACK TOGETHER AND USE IT.
I HAVE 2 3020 GAS TRACTORS FOR SALE IF YOU KNOW OF ANYONE LOOKING FOR A 3020

 

[twopop]

you can order the seals and bushings from bolingmachine.com for 55 dollars a pair.or you can get the same seals for 146 dollars from deere.
I have been using the boling mach. seals for several years and they work very good

 

[travz500]

go to jd and get seals bushings and the shaft for the cost of hygard its not worth going doing the job more than once since it will drain most of your oil when it decides to leak and make sure the vent in the cap is open and clear our 4010 had cap vent plugged and it kept leaking replaced seals twice before the dealership told me to check the cap and it was plugged and building up pressure just something to check by the way your talking about the load shaft seals right

 

[Ranhil]

thanks for all the replies. One question. Vent cap plugged. Not exactly sure where you are talking?

thanks
Randy

 

[travz500]

the cap where you fill the hydralic oil up it is a vented cap they told me to clean with carb cleaner or take it to the parts washer and clean up with solvent

 

[Jason from MI]

KEV4440,
Where are you located? Got any pics of the 3020?

Jason

 

[tim s]

I put the new style seals in and the original style too be sure you don't have to much end play on the bottom shaft, this is what eats them up the constant back and forth motion,, shim it up tight..

 

[Anonymous-0]

what year is the 3020 and were is it located

 

[tim s]

Yes no one thinks of that but they are normaly plugged tight, we clean them as we work on them,it's not realy a very good breather...

 

[John Heine]

I use the seals from Boling Machine.I also put new bushings in case and new shaft.

 

[Anonymous-0]

I'M IN IOWA MY CELL # IS 712 369 1445
THANKS

 

[Anonymous-0]

MY CELL PHONE # IS 712 369 1445