Just replaced the full set of standard Clevite bearings on the engine & left the crankshaft standard. The main bearing caps were previously shimmed but the connecting rods had none.
Upon reassembly using the manual's torque specs. the engine is too tight & will not turn (even with a pry bar).
So the question is, what shims are typically added to the connecting rod caps?
Any help is appreciated.
Thanks,
Gary
Upon reassembly using the manual's torque specs. the engine is too tight & will not turn (even with a pry bar).
So the question is, what shims are typically added to the connecting rod caps?
Any help is appreciated.
Thanks,
Gary