got a 460 with a 301 gas in it with a new pressure plate and button clutch. took it to the pull today and tried to pull in 2nd and 3rd gear but it wouldnt pull off. put it in 1st and it pulled off and spun the tires in 5000 and 5500 lb classes. had a few guys think the pressure plate isnt strong enough to hold it in those gears. what do you think could be the problem.
 
I had almost the same problem, My flywheel wasn't flat. I had had it broached at a machine shop, but they didn't get it flat. Took it to a speed shop and he made both pieces, and the clutch disc flat. no problems. He said I had to many buttons for the power I had. Told me to slip it in 5th really hard before I pull to warm it up. You might try this before you take it apart. Vic
 
JD Plowboy, The flywheel step should measure 1.188 inches.If it is more than this it will not clamp as tight as it should. If it is s little less it will clamp tighter but the fingers will be closer to the release bearing.
 
brad noticed friday night when we talked to another guy about it and he said the fingers needed to be riding close to the release bearing and when he pulled the bottom cover off that it was about a 1/4 inch away from the release bearing and he adjusted the fingers to the release bearing. after that it done the same thing saturday.
 
If the fingers touch the throw-out bearing, you will have no free travel and are taking pressure off the springs.
 
it didnt change anything. it still wouldnt pull off in either gear but first. talked with a guy that built my last puller and he said the pressure plate is not strong enough
 
Unfortunately a stock 301 will not pull in 2nd or 3rd. Jack up the RPM's to 3000 to 3500 pull in 2nd with the TA back. Worked out well for us.
 
there was a stock one that pulled with us a few years ago that would pull in 2nd and 3rd gear and one that pulled at the pull we were at this weekend that can pull in 2nd and 3rd gear. i know him personally and have seen it myself. the one a few years ago would pull up to 6000lbs in 2nd gear.
 
A decent running 301 should pull the 4500# class in straight 2nd, (torque ahead) the 5500# class in 3rd torque back and the 6500# class in 2nd torque back. Are you sure the clutch in the torque isn't slipping and it is not the main clutch? My 460 didn't ever like to take off in 4th torque ahead. I left the line with the lever back, got going and shoved the lever forward. If I didn't it would sit and slip.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top