504 doesn't like a load

I have a gas International 504 utility that really runs bad when it is put under a load. When idling, or just moving from here to there, it is OK, but try to fill the loader bucket, or pull something like a plow, it misses very badly, and the smell of gasoline gets thick. Does this sound like an ignition problem, and if so, what is the cure?

Thanks
 
Get both the ignition and fuel systems properly serviced and adjusted. Perhaps the ignition system has a problem. It is certain that the fuel system has problems.
 
Sounds to me like the main jet of the carburetor is misadjusted, probably a little two rich, though it could be that the air flow into the carburetor is restricted by the choke being partly closed and by nests of birds, wasps, and mudaubers plus a very dirty air cleaner. Could be the intake air hoses are collapsing under vaccuum.

Try closing the main jet 1/8th turn at a time after checking for all those other things.

Gerald J.
 
missing: I had a 504 gasser, and at 1,500 hours with a fresh IH dealer engine rebuild, it ran just like yours. Tune it up and 5 days later it was same thing all over again. My suggestion, get rid of the 504, I did. 504 gasser, definitely the poorest tractor IH ever built.
 
Had a International 2400A with a C175 gas engine. It ran very poorly after I overhauled it. Put in Champion D21 sparkplugs or equal and it ran for a good for many years afterwards. It would not run on what is considered standard plugs. D16s
 
Check the spark irst. It should look FAT AND BLUISH-WHITE, the color of lightning. If it isn't then you need to find out why. Make sure the timing and advace are correct. If that's fine then make sure that the carburetor mixture is correctly set.
Sometime you have to enrich it it when you are putting it under heavy load. Since you say that it smells overly rich, pull the plugs and look at them. Is there dry, fluffy deposits on them. If so, that's due to a rich mixture. Sometimes if you have an air leak downstream of the carb metering section( thottle shaft, connect flange gasket between carm and intake manifold,or the intale manifold to cylinder head connection or a cracked intake manifold) you enrich it to run good at idle and it' too rich for high speed under load. The fix is to find the iar leak and fix it and then readjsut the carb.

Hope this helps.
 
Well here are a couple things to check , First change your plugs to autolites or motor crafts next clean up the ft pulley so ya can see the timing marks at between 20-22 degrees at RATED PTO SPEED . The timing for the earlie s/n is the 22 degrees and the 20 degrees is for the later engines and one other small thing CHANGE THE GAS YOU ARE USEING as the 504 falls under the 93 octane minimum req. for that engine . you vary well could have pistons swelling thus causeing the lack of power under load , Now correct me if i am wrong here but the 504 gasser had a selenoid fuel shut off on the carb and as long as the tractor starts then it is working and it goes into full fuel mod when the key is on . Now if by chance it still has the org. fuel shut down on it it may have a fuel adjusting screw in it and they should be set at 4-5 turns off the seat . Don't try and wean it back as lean is mean and can cause you more problems them ya want.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top