5640 Loader Valves

[Willowfarms]

Do you happen to have a p/n for your hydraulic valve?

 

[chevytaHOE5674]

I used Prince 20 series closed center load sense sectional valves. All 3 spools are spring center dual acting.

 

[JJL]

Do you happen to have a p/n for your hydraulic valve?

I added a CCLS loader valve to my 5610 a few years ago. I went to my local hydraulic shop, Kundingers, to get everything except the loader valve. They had a shuttle T and made up all the hoses & fittings to get it together. I removed the steel lines for the shuttle T and used hoses.

 

[Willowfarms]

I added a CCLS loader valve to my 5610 a few years ago. I went to my local hydraulic shop, Kundingers, to get everything except the loader valve. They had a shuttle T and made up all the hoses & fittings to get it together. I removed the steel lines for the shuttle T and used hoses.

What did you use for the loader valve?

 

[Willowfarms]

Any info on the thread size of the filler neck tube? And what size hoses for supply/return?

 

[JJL]

Here's the valve I used https://www.hydraulic-master.com/fr...ons-joystick-controller-ls-closed-centre.html

 

[JJL]

Think I used 1/2" for pressure to valve and 3/4" for return. Not sure on all the fitting thread types. Might be different on your tractor anyway. Best to take off the lines you need to change and take them to your hydraulic shop to match them up

 

[Willowfarms]

Hi all, it’s been a while since the last post, but I have finally gotten around to getting the valves installed and I have a question. My tilt up/down and lower work great. But my lift function is very slow. You have to pull back to raise and it will take a second or two before it starts moving and then raises very slowly. Any suggestions?

 

[chevytaHOE5674]

Pull back to raise your loader and at the same time pull one of your remotes into the extend or retract position, and see if that changes the loaders speed.