'68 JD 4020 syncro-trans shifting difficulty

Beefalo

New User
We just purchased our first 4020 a week ago today. It's a '68 with a syncro trans.

It worked great all last week until Friday.

I fired it up and it won't go into any forward or reverse gear.

Tried adjusting the clutch pedal, and it still won't go. It moves the full length from the park position at the top to bottom in the left side. It will go to the right in each section but won't go into forward or reverse. It makes a high speed grinding sound.

Only thing i did to it since we purchased it was to top-off the hydraulic fluid because it was low.

I can't imagine whet could have happened over night from Thursday when it worked fine, to Friday? It's kept inside, so weather shouldn't be an issue.

Any idea's?
 
Hi Just a question here since you put the oil in
does it have oil dripping out under the clutch
housing. I wonder if the oil is leaking out
through the clutch input shaft seals, Running
along the shaft and into the clutch disc, Then
sticking the clutch disc up to the drive faces
making the clutch drag. I've seen a few other
makes do this in my time.
It could be any number of other issues too so it
might be easier to find a local self employed
mechanic outside of a JD shop that works on them
to come look at it. JD shop rates for mechanics
are not cheap and neither are genuine parts they
fit to fix the problems.
Regards Robert
 
There are two linkages. There's a latch in the shift quadrant that flips over so only one linkage will move at a time. Sounds like that latch isn't flipping over and it's trying to move both rods at the same time.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top