703 ford loader Help if you can !

Jr150

New User
I'm rebuilding the control valve it's the 19-97 dual spool i have it almost done But there's 2 plastic balls in there at the relief valves that are of course NLA. I have one that is worn oblong and need to find a replacement. I think it has somthing to do with when i go to raise the lift arms they drop before the lift unless i pull back quick and hard then they rise fine. Not a good thing for doing anything fine though. Any ideas, i thought of makeing 1 but it must be a weight deal with them or they would be steel, there 9/16ths hard plastic. This is on a 1960 841 i know i can get a new control valve but i'm trying to keep it all 1960 same as me. Thanks JR.
 
I used a steel ball bearing from the local hardware store on the valve body for my log splitter when the plastic one gave up the ghost. That was about 12 years and at least 100 cords of wood ago with no problems. I'm not saying it is correct, but it worked for me. I believe that the ball is under spring tension, right?
 
I remember a former hardware store had small plastic & rubber balls in their plumbing dept . A good ole plumber should be able to help you out . Let me know what you find out since I have a 19-97 loader with that control sitting in the yard to mount someday (I hope) & I have no idea of my controls condition .God bless
 
'


Those sound like "load check balls". Loader control valves have what is called load check. When you move the control, the loader arms stay put, until pressure builds up and the load check ball is displaced, then fluid can flow and the arms go where you want them to go. Without the load check, tipping the control would allow gravity pressurized fluid (from the weight of the loader frame, bucket and what's in the bucket) to flow backwards -- that would let the bucket drop swiftly.

I would try and find some plastic balls. Steel would work, but they will wear the other side of the load check. It just depends what you want to wear, the cheap $0.03 ball or the expensive $300 control valve body.

Have you tried "fastenal"? Or some of the industrial supply places?

jb
 
I've used Mcmaster-Carr for items like this in the past. I checked their online catalog and all they have in 9/16" plastic is HDPE which won't last long. They do have 9/16" brass which is probably what I would use. They are $9.10 for a pack of 10. Part #9617K44.
 
John your exactly right on your explanation. You men sure have given me some places to shoot for. I wondering if the steel would work i can find them. No there not under any kind of spring tension it's flow that moves them about one is just so badly deformed i'm sure this is all thats wrong since it wasn't leaking very bad mainly under the frame where the filter meets it . the spool O rings were 12 bucks a peice at good ole NH needed 4 of those. well thanks i'll keep checking back and i'll let all know how it works with 900 lb rounds on it again thanks gentlemen. JR.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top