7610 Flywheel

gebell1301

New User
Anyone know the specifications for the 13 inch flywheel on the 7610? While replacing the clutch assembly I had the flywheel resurfaced. Now the clutch doesn't fully release. Looks like the flywheel is the problem. Bottom line I need to know the minimum acceptable thickness for the flywheel.
thanks!
 
Don't have the dimensions, but are you sure you put the
pressure plate on correctly? And did you put the banana spacers
back between the flywheel and the pressure plate? The pressure
plate only fits on one way (there's a thick and thin dowel) and I
have made that mistake once. It would slip under heavy load and
not disengage all the way. I want to think that the flywheel isn't
stepped, so that shouldn't be a problem, but it's been a while
since I have had one of our 10 series apart for a clutch. Also, I
believe the clutch plate only works correctly in one way (like I
said, it's been a few years, so there are some cobwebs upstairs
lol). Hope this helps. We had to put a new flywheel on our 7610
a while ago because it had warped, but I don't believe that is
very common.

Hurst
 
I'd have to look in the book to find the spec. No doubt it's there... but I can't really see that being your problem unless you really went to town with the grinder.
Did you fit the clutch correctly? ie. observe the 'flywheel this side' markings if they were on the disc or alternatively fit the pot of the disc into the flywheel pot and check carefully that the disc fully seats?
I can't remember right now if there's dowell's on that flywheel for the pressure plate... but if there is and they bottomed it could possibly hold the PP out... or if the PP bolts bottomed and didn't fully tighten the PP to the flywheel.... that could be a problem.
Otherwise it ~should~ work even with a worn/thin flywheel IF all of the above criteria is OK.

Split it again and make sure the disc isn't bent too...
I'd also check for worn pin holes in the linkages and a broken pinch bolt in the cross shaft/release fork. BT/DT...


Rod
 
Good luck finding a spec for minimum flywheel thickness in the repair manual - it aint there. There was a service bulletin that came out many years back, that basically said you were allowed a max of .080" to be removed.

Biggest problem with surfaced flywheels is the clutch disc springs hitting the flywheel bolts. You can gain about .020" or so by loctiting the pilot bearing and leaving the washers out.
 
One other thing I just thought of, but did you check the pilot
bearing when you had it apart or replace it? A bad pilot bearing can
cause what feels like a dragging clutch.

Hurst
 
Yea, it was on correct (unfortunately). The clutch didn"t slip, it just didn"t fully disengage. I"m trying to eliminate everything that could possibly cause the problem. I had the pressure plate and disk checked and the shop recommended looking at the flywheel. Said this is what happens if the flywheel was cut too far. So I"m trying to get the spec"s. Thanks for the response!
 
When the clutch assembly was replaced the pilot bearing and the throw out bearing was replaced. Additionally the clutch input shaft was replaced. The disk was installed IAW the shop manual. The pressure plate was fully seated (none of the bolts are bottomed out nor are the dowel pins holding the pressure plate off the flywheel. All mechanical linkage has been checked. The only other thing I can think of that could cause this problem is the throw out bearing. If it wasn't the correct thickness, it wouldn't move forward enough to fully release the clutch. Just a though. Thanks for all the suggestions and insights. They have made me retrace my steps and re-verify everything!
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top