806 pressure testing.

rustred

Well-known Member
i got back to this 806. i checked more pressures. at 1200 rpm i have 20 lube pressure, operating is 205 steering is 250. when i dead end the steering wheel each direction i have 1700 psi. the torque lever in high is 250 in the middle its 240 maybe slight decrease when shifting to low, which is 250 psi. also dump valve is working builds psi just before tractor goes to move. brakes work good and push back at you when stepped on. all i am concerned about is when the oil gets hot the lube drops to 4 psi. so just want to know what is this lube psi oiling? and is it ok to use it as is at 4 psi? and yes the filter is new and clean. looking for 2 answers.
 
Ya want to do your pressure testing with the oil at operating temp above 160 degrees . Clutch lock up if it stays at 250 is good all but lube pressure . That should be holding around 20 , could be a weak spring on the lube circuit or maybe a blowen gskt on the MCV . Dump vale should be set as i have layed out the way i have posted . I prefer running a flow test as i am doing the pressure . The little red box tells me more .
 
what about trying lucas oil treatment in the trans oil for some viscosity? just for an experiment.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top