860 keeps dying

Papa's41

New User
I've had a problem develop on my 860 and I'm stumped. It was running fine, then recently it has started dying once it reaches operating temperature. If it cools down (1-5 minutes or so) it fires right up and dies again a few minutes later. It acts like it's starving for fuel or air. Just had to hold the choke half closed to get it back to my shop.

I've done a complete tune-up w/ plugs, wires, condenser, points, rotor/cap and the timing is good. I've also cleaned the oil bath/air filter and screen/sediment bowl. Before pulling the carb, am I missing anything else?

Also, does anybody know what the resistance should be for the Primary and Secondary coils?

Any thoughts or recommendations would be appreciated.
 

Clean and overhaul your carb. To do this well you need to soak the disassembled carb in a carb cleaner bath for several hours, rinse it with a garden hose with a nozzle and blow it dry.

BE CAREFUL NOT TO LOSE ANY OF THE SMALL PARTS.
 
Before you buy any more parts that you may or may
not need, figure out why it's dying. When it dies,
immediately pull a plug wire and see if it has a
strong spark, able to jump 1/4" or more. Also check
to see if there's a vacuum on the gas tank after
it's been running a while. Maybe your vent has
gotten plugged.
 

Hey, don't condemn your carb until you know that it is getting gas. Not just a teaspoon full but enough so that when you remove the drain plug from the bottom of the bowl, that it will run a good stream for twenty seconds. If it is getting a strong flow of fuel and it won't start, then you may remove it.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top