(quoted from post at 23:50:48 01/29/09) I am wondering if you can order .010 over pistons 4 8n or do you have to rresleeve I have cast sleeves.any info would help

Is your intent an attempt to gain HP or do you simply want to correct wear? New sleeves are $20 ea. and get you back to OEM bore real simply. Oversize pistons are going to be all of that and more. Its not likely you can drop .010 oversize pistons into a worn OEM sleeve without some resizing sort of work (hone/rebore) on the sleeve. I suspect a new set of sleeves AND pistons with rings is less than the cost to have a machine shop rebore 4 cylinders.

TOH
 
If you are thinking you can put .010 pistons in the standard bore because that much or more is worn out of the top of the bore you are mistaken. Althogh the top of the bore may be worn that much the bottom of the bore is still going to be closer to standard size still. That's the way engines wear. More at the top than at the bottom of the bore. If you want to put .010 pistons in it you will have to bore it to .010.
Can't do it.

Zane
 
A major reason upper cylinders wear more than the lower ends is SLOW IDLING! (Sorry, Dell.) SLOW IDLING for LONG PERIODS starves the upper cylinders of lubrication due to NO OIL SLING from the crank/lower con-rod squirts.

Avoid long periods of slow idling. It ain't good for engines, even if it does sound good to hear them run smoothly at low rpm.
 

Almost all the replaced sleeves are 0.090 wall thickness, with some of the early blocks having to be bored to take the thicker 0.090 sleeve. If the sleeve is tight in the bore and not otherwise damaged you should be able to have it bored like a normal engine assuming you have the 0.090 sleeves.

Apparently my engine was originally a thin sleeve engine, having been rebored for the thicker sleeves. The sleeves were set just slightly lower than spec. That is why my machinists didn't want to change them, he figured if they botched the counter bore for the top shoulder, what else would he run into, like gobs of lock tite etc. Apparently he had a bad "resleeve experience". Maybe suffered from post resleeve stress disorder, PRSD. =;^)

We ended up boring 0.040 over size. I am not sure where he got the pistons. Take a look at the parts section of this site. I have been happy with the results.
Hope this helps.
 
I bored a block .030 over and the guy changed his mind on the pistons and wanted a set of .040 he had found .

It was a real pain to center up to bore that .010 from a fresh bore . That's .005 from each side . An average hair from your head is .003 to .004 thousands . A worn bore would be extremely difficult

Cylinder bores do no wear evenly . Most of the blocks I have bored dont start cleaning up and running true until .008 to .015 if there's not a big scratch in it . I have had a few that had to go .040 because .030 would not get it. Its rough to get to the last hole and find out it wont go because you have to re punch the ones you just finished . A dial gauge will tell you the size but not if the amount worn is evenly spaced are more to one side .

They do make a big bore kit with 3.270 pistons and .049 sleeves to replace the 3.1875 pistons and .090 sleeves . If you got a set of those pistons (.082 +/-) then you should be able to bore the sleeves you have if they are the .090 sleeves.

You should get a 1hp increase which is probably not enough to notice for the additional cost of the over sized pistons .
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top