davidbrodhead
Member
just did an ignition tuneup on my 6V 9n.when the distributor cap was mounted the rotor tip was hitting 2 of the distributor terminals.I was rotating the assembled distributor by hand and noticed this issue. I filed the rotor terminal a little to stop the interference.When I mounted the distributor on the tractor , it runs, but not real clean.Starting is a bit slow also. I read some stuff on the internet about that gap and it seems to show .015 to .025 is a desired gap. They say too small a gap or almost no gap is a bad thing.Any ideas here.I don't know where I got the parts I used, they were in a drawer of reserve parts.The bearing in the distributor seems OK.