Agco Gt65

[sstterry]

This message is a reply to an archived post by Bill in IL on February 26, 2017 at 07:42:50.
The original subject was "Re: Agco Gt65".

I have inheritated and AGCO GT65 from my father and I need to change the oil. For the life of me, I can't find the drain plug on the bottom. There is one place in the manual that shows a 6 sided plug, but I have no idea what tool to use on it. Any advice?

 

[kcm.MN]

Sounds like it'd use the appropriately sized hex key. Most likely metric.

 

[Jim.ME]

It looks like the plugs are in the side(s) of the oil sump, not the bottom. I would agree with kcm.MN that you need a metric hex key, given all the hardware listed to mount the sump is metric.

 

[Bill in IL]

Those are an allen head on the side of the oil pan if i remember right. Good sized metric allen head 15mm or so? Not sure if that one has one on each side or if i am thinking of another machine.

 

[sstterry]

Thanks to all that answered.