LonnAC7050
Member
This message is a reply to an archived post by Dave from MN on November 12, 2011 at 17:54:19.
The original subject was "Allis 7580?".
Did you ever get it? If so retuning the engine RPM down to 2400 does wonders for engine life. If the right shop does it you won't lose any power either. Also for a time AGCO or Deutz was getting bad rod bolts that would break even before the tractor left the shop, so I'm told. The sure thing to eliminate that is to check and make sure you have ARP bolts installed. It's what AGCO sells these days and they are the best and won't break.
The original subject was "Allis 7580?".
Did you ever get it? If so retuning the engine RPM down to 2400 does wonders for engine life. If the right shop does it you won't lose any power either. Also for a time AGCO or Deutz was getting bad rod bolts that would break even before the tractor left the shop, so I'm told. The sure thing to eliminate that is to check and make sure you have ARP bolts installed. It's what AGCO sells these days and they are the best and won't break.
