Another funny

4520BW

Well-known Member

cvphoto118838.jpg
 
Staged photo. I don't believe anyone has ever gotten a broken bolt out with a tapered spiral extractor. I know I haven't, only splined or square works for me.
 
I have a time or two . Usually dont mess with it unless its somewhere I cant get a welder . If they are very stuck an easy out hasnt ever done me much good .
 
If it was loose enough to come out with a spiral extractor, it would have spun out when I hit it with my left hand drill bit.
 
Yeah, right. 3 broken head bolts in a cub last week. Drilled first one stuck an EZ out in there, didn't even twist it hard, snapped off..... Hours later we got it out. Second time that's happened, wife threw the rest of the EZouts in the recycling bin. BUT, it is an awesome feeling when you get those broken bolts out!
cvphoto118846.jpg

Used these to remove the extractor
 
Yes, welding is best, unless I don't think it's too tight, then left hand drill bit and a square extractor is what I use.
 
Irwin makes the best square extractors I've found. They were recommended to me by a friend that is an industrial machinist, he digs out bolts that are broken from stress daily. He got me a full set for Christmas one year.
 
All depends on why the bolt broke, and getting the hole drilled without walking off, intersecting the threads.

If it was over torqued, or stressed, and the threads are still free and good, then the EZ out will work.

But if it was bottomed, seized, or rusted, and twisted off, nothing short of drilling and tapping the remains out will work.
 
All I have is tapered spiral extractors, I have had mixed results but most screws have come out with them. I agree with Gene Bender drill the right size hole well centered and they can work. I am not saying the square ones aren't better I just don't happen to have any so have never tried one. BTW I have never broken one.
 
A photo with the caption of, the agony of defeat, with a snapped off extractor next to your photo, would make your funny complete.
 
My preferred methods, weld a nut on, drill heat quench (repeat) use square easy out. Welding a nut on has surprised me a few times, sometimes you need to repeat it. Sometimes its best to heat and pound before you twist it off. The craziest success I ever had was on a lug nut holding on an aluminum wheel. We had tried about every thing and the nut was a rounded off mess. I lite the torch and aimed it at the stud and when the stud started to melt I hit the O2. It blew the stud out of the center of the nut clear down to the axel flange. Not a mark on the wheel.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top