belt pulley

[Anonymous-0]

Does anyone know if a belt pulley that can be attached to the pto by 4 bolts on a TO-20, TO-30, or a TO-35 can also be used on a ford 8n or ford naa by attaching the 4 bolts the same way. Is the 4 hole bolt pattern the same?

 

[Bob (Aust)]

Can't answer youir question but if you find PTO shaft requires a spine adaptor to connect with the Ferguson belt pulley, contact me as I have photos and a drawing of a simple mount you can make to accommodate the spline adaptor.

Bob in Oz
'53 TEA20

 

[Richard L]

I am positive the pulleys are interchangeable between the TO/TE's and the N's, at least in the original style of 1-1/8" PTO shafts.

 

[Jeff-oh]

Yes the 4 bolt pattern is the same.

The belt pullies come in both the 1 1/8 orginal size and the 1 3/8" current standard. So you'll want to know what you have and what you are buying.

Jeff

 

[John UK)]

They will interchange, if you find one with an 1-3/8" shaft and your tractor has 1-1/8" shaft, you can get a sleeve that fits in the Pulley to make it fit. If you find a Pulley with 1-1/8" shaft and the tractor is 1-3/8" you can make a spacer and use four long studs into the Tractor to use it.There used to be a kit for doing just that.
John(UK)

 

[Anonymous-0]

i have whatever you need

 

[Anonymous-0]

If you could send picturs or a drawing of the extension, it would be a big help. My E-mail address is [email protected]

 

[Anonymous-0]

I am trying to find a replacement set-up for a front mounted loader drive on a 1952 TO 30. The crank pulley and entire drive to the punp is shot. I"m looking for a new, or new used pulley and drive set-up to conect to a front mount wagner loader. Any help or info on the subject would be helpfull.