case dc water pump

[supercrew1]

Anyone know how to disassemble a water pump on a case dc? Does the impeller screw off? What direction?

 

[Anonymous-0]

need to pull the impeller off with the two threaded holes, then shaft comes out the front after removing snap ring in front of the brg.

 

[supercrew1]

Thanks for the help.

 

[Anonymous-0]

you will need to face the sealing surface in the pump on a lathe and probably build up shaft where seal boot sits as often they are pitted, I have used seals over after lapping the carbon seal with sand paper on a piece of glass if it isn't broken

 

[supercrew1]

I have pulled it off and it has a broken seal. Will I have to buy a complete water pump or can I just purchase the seal kit?

 

[Anonymous-0]

As far as I know, kits are no longer available.