BeeselDietle

New User
Hi all, I have a case m1394 tractor that I am trying to replace the seals between the final drive and the transmission housing. I hope someone can give me some tips on getting the collar out that holds the seals in. I made a puller from a harmonic balancer puller and some steel plate, but I cant get it to budge. Any ideas?

Thanks in advance

James Perry

I posted this in the tractor talk forum, then realized I should have put it here, sorry for the double post :oops:
 
hi if you mean the seals on trans side of final drive the collar should have two jackscrews in it,they should be unc thread hope this helps.
 
(quoted from post at 17:23:16 07/23/08) hi if you mean the seals on trans side of final drive the collar should have two jackscrews in it,they should be unc thread hope this helps.

Yeah, I found the jack screws, but all they did was push the old seals out into the transmission. That is what I have my home made puller hooked to.

I took my harmonic balancer puller and backed it up with a piece of steel plate with holes drilled in it for the jack screws and center bolt of the puller to pass through. I took another piece of plate and welded four large nuts on the back of it, so the puller centerbolt could press against the plate and not be against the collar. It's tight enough right now to flex the steel plate and it 38" plate.
 
hi just looked in a repair manual it says to use a flat steel bar with two jack screws towards ends,it olso says to pack grease between seals and apply gasket sealer to outside of seal retainer hope this helps.
 
Seem to remeber using long 1/4 or 5/16 unc bolts that just screwed right in and drove the collar out,But I think there was a service tool to get it out.They were however always bloody tight
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top