case t6 spreader

[kenbob]

I know this might be better on implement page but Case guys know best. Is it hard/expensive to replace the floor on a case t-6 spreader. Rest of the unit looks good from the pictures. Neighbor wants one for his small herd. I saw this one but could use advice.

 

[casecollectorsc]

I know this might be better on implement page but Case guys know best. Is it hard/expensive to replace the floor on a case t-6 spreader. Rest of the unit looks good from the pictures. Neighbor wants one for his small herd. I saw this one but could use advice.

I've done it with green treat 1" lumber. The floor is wider at the rear than the front by a little bit.

 

[kenbob]

I've done it with green treat 1" lumber. The floor is wider at the rear than the front by a little bit.

Thanks. The info will help. THere is an older NH nearby as well with same issues. Both are ground Drive, which is what he wants.

 

[Hoofer B]

I ve done it to an IH many years ago. Not too hard. Use tongue and groove green treated lumber

 

[jon f mn]

I did it with a Minnesota brand a few years back. It's not hard, but takes longer than you think. I was surprised how long t took me, but that one needed sides too.