Clockwise or CCW

I have this AC grader and am replacing the engine.NOW it is going into a configuration that is backasswards to the normal getgo,that is to say
the engine is behind the operator and I am assuming that the airflow is out the rear of the grader. So is my assumption correct or will the airflow be normally across the radiator and engine. Boy am I confused.My dilemma is which way does the engine turn and from what perspective? ALLAN NE what do you have to say about this OR anyone else who wants to join in. CC
 
Do do have ANY reason to believe the engine DOES NOT turn CW when looking at the ENGINE in convention fashion, at the end opposite the flywheel/clutch? In other words, looking forward from BEHIND the machine in this case, at what would conventionally be the "front" of the engine.

Is it a Detroit "screamer" (as many of those graders used?

No matter WHICH way the engine runs the fan blade could be configured to blow the air forward OR rearward.

I remember quite a few years ago our county had two nearly identical CAT graders. One had been "spec'ed" with the fan blowing rearward, the other one frontward.
 
Engine rotation does not change. If it is like most d model ac graders it is a wd45 engine just get a farm tractor fan. Rotation of engine is the same you just changed how the e gine was sitting. Most of the old d graders had the air coming thru the radiator in a conventional fashion.
 
Pretty rare to find a gas engine that turns CCW. The general standard for engine rotation is the engine is veiwed looking at the 'front' or water pump end. The flywheel end is the 'rear'. Fans can be confusing as to push or pull on industrial equipment. I have a Hobart G-3010 engine drive welder with a Chrysler 225 slant 6 engine. The rotation is obviously CW and the fan pushes the air out thru the radiator. Presumably this is done to pull cool air in thru the rear of the unit over the generator sets then the engine. On a rear engine grader it's likely done to force the hot air out the back away from the operator station.
 
It doesn't really matter which way, it will cool the radiator by blowing air though or pulling it though. Just use the original fan that came with the grader if you have it.
Walt
 
If it has a Detroit 2 stroke motor,those can be built to turn either way.I think you turn the cam around to change the rotation of the motor.I dont know if thats what you were asking about for sure.Heres what I think,if the engine is turned in a forward gear in the rotation you think it turns,and the machine goes backwards,you need to turn the cam around to get it to go the right direction for your machine.If its a gas motor it probably only turns one way,and if you need it to turn the other way you woulod probably need the cam and crank out of the old motor.Just a guess.If itsw the fan blades you think are turning the wrong way,most construction stuff was made to where you could change the blades to push air through or pull air through the radiator.
 
Some years back, our local fire company bough a used engine/ generator combo, to be used to run the siren and the radio, in case of an electrical failure.
As they were watching it run, somebody sez:" Thats funny--the engine runs backwards!"
Here the fan was blowing air out thru the radiator away from the engine!
Being an old hand at that kind of stuff, i just stood there and nodded my head in agreement!
Yah, sure! Took them several weeks to notice that the engine wasn't running backwards! I got a good chuckle out of that! And several more weeks to figure out what was really making the air go the wrong way!
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top