Clutch driver

Ben Rauls

Member
My B sn#213000 trying to get the clutchdriver off, has 2 threaded holes, do you run bolts in to bottom out and pop it off or do you have to use a puller?
 
elkagg, I once followed somone"s advice about just screwing the bolts into the driver... I twisted a 1/2" grade 8 bolt off in the clutch driver. On that vintage B, the holes don"t go all the way thru. On other models they are tapped all the way thru and you can push the clutch driver off by just screwing the bolt in.

You need to either make or get a puller that lets you use the (2) 1/2" bolts. Put the bolt back in the end of the crank (w/o the washers) so you don"t bugger up the end of the crank. Don"t try to pull on the outside of the driver.
 
I pulled the clutch driver from a 530 a couple of weeks ago.

I used a short piece of square tubing as a puller. I drilled two half inch holes in the tubing spaced the same as the hole spacing in the clutch driver. Half inch capscrews went through these holes and into the clutch driver. An appropriate length spacer between tubing and the end of the crankshaft will pull the driver off as the screws are tightened.
 
You need a service manual. JD made a nice one for that model and several companies sell reprints, Deere even still sells them too.
 
Since there seems to be so much confusion we better get it cleared up.

Late B above 201,000 has threaded bolt holes that are to be used with some sort of pulling device. Use the one of your choice.

Early B and ALL A tractors use two square headed bolts for driver removal.

The bolts screwed all the way through the driver system is used on 70, 720, 730. It wont work on a B of any vintage.
 
if you screw the bolts all the way in it will ruin the inner clutch disk. put some tension on it and in my case i took a torch and just went all the way around the assy real uick and within 5 seconds or less it just popped right off. did it so fast it scared me. if you replace the bearing and the oil lite or brass bushing the brass bushing has to be set inside 1/4 inch. you need a manual bad to get this right. there is a drain hole in the cover that you need to be sure is open. if you remove the clutch shaft from the forks be sure and mark where it goes back on so you'll be able to put it back in at the right angle. when i took mine apart the spring the the forks rides on was rusted into and wasn't suppoeting any of the weight of the assy and it was wearing the parts into. if you first reduction gear cover doesn't have the holes in it to add oil and drain oil fro the first reduction gear you need to do this while your into it. don't drill a big hole to drain or add oil since the older castings are very thin and if you drill for more than a 3/8 pipe plug you want have enough threeads for the piep to seal off good with.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top