(800) 853-2651
SHOP NOW

cub

Yesterday's Tractor Forums
A

Anonymous-0

Well-known Member
1949 cub is using hyd.oil no external leaks believe oil is getting by pump into engine crankcase. what is involved in this repair? thanks !
 
Acman; Not an expert doesn"t look to be to big a deal. Just be sure and work in in a very clean place. There is a kit with all gaskets and O rings IH part number 355208R91 also, check the part number on your pump if it is 352035R91 you will need to buy an other O ring p/n 355742R91, this is not in the kit and the one in the kit must not work. Good luck

Bob
 
The seal on your pump has probably become harden
from age and it may have worn a groove on the shaft where the seal rides. There's speedi-sleeves available to cover that worn area if yours is worn. Here's a breakdown on a pump. Your pump may be similar. Hal
403wkes.jpg
 
You must log in or register to reply here.
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top