d19 cockshutt 50

[jason ferfecki]

Can I put a d19 head on a cockshutt 50?

 

[Anonymous-0]

its best to call 716-308-5987

tks mike

 

[Anonymous-0]

I think the bolt pattern is different but can't remember, I may be wrong. The gas head off a D-19 is flat though. If you could put it on you may run into compression and piston clearance problems right off the bat. The diesel head actually has combustion chambers in it.

 

[Gary H.]

Water pump will present another problem. The 273 Buda mounts different

 

[red bull]

I used to pull aganst a Cockshutt 40 that had a d19 engine. So I know it will go with some switching parts from your 50. I put a 3400 Herculese in my 40.

 

[red bull]

I misread your guestion, I'm pretty sure you can't put the d19 head on your 50 but you can put the engine in it.

 

[blackangus]

Have one on my 273, chev car pistons runs good

 

[Anonymous-0]

Will a 3400 bolt right in or do you to make s lot of changes to fit the herc into the 50 ?

 

[red bull]

I did this about 10 years ago, best I remember I used a 570 rear engine plate and flywheel, you have to make a few little changes such as throttle and radiator hookups, elongate holes in frame for front motor mounts. The exhaust exits out the left side, I made up a pipe that crossed over under the hood and up through the original hole.