(800) 853-2651
SHOP NOW

D8H

Yesterday's Tractor Forums
P

peter82

Member
does anyone know what the intake , exhaust and compression release set on its a 46a13000 whats the best order to set them in thanks
 

Intake .018, X .030 .020 for the compression release
theyer is a way to set them with one revolution of the emgine. get #1 TDC ad set half then get #6 6 up
I will have to get my book to tell you what to set with each TDC.
 
Pete, set #1 cyl on TDC compression(#6 valves on the rock). Then set both valves at #1 cyl and then set Intake/Exh/Intake/Exh on alternate cyls down to #5 Exh. Then turn the engine one revolution and set both valves on #6 cyl and the Intake/Exh/Intake/Exh again on alternate cyls up to #2 Intake. Set compression relief rods as you do the corresponding valve.
Later Bob
 
You must log in or register to reply here.
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top