oliverkid

Well-known Member
Just put a fresh overhauled Roosa Master on my 1950T and now Ive got a problem. #1 line is leaking so bad at the banjo fitting that it wont even fire the injector. Ive tried flipping the washers, flipping the banjo fitting. Even tried a set of washers off a CAV pump I had laying around off a 372 perkins. No matter what I try it keeps blowing fuel straight up and straight down at the face of the port on the pump. Any suggestions other than CAV 5936 332C washers? Really dont want to pull the pump back off and drive an hour to take it back to the pump shop cause Im to the point where I need this tractor back up and running.
 
This is a strictly do at your own risk recommendation. The bolt also is designed to bottom out when it is tightened. Screw it in the pump without the banjo and see if it is bottoming before you are getting a good crush on the washers. If it does not tighten enough grind a bit off the shoulder on the tip matching the original angle. A flapper wheel on a 4 in. grinder or a bench type belt sander is the best way. DT is going to cringe when he sees this.
 
are you 100 percent sure the banjo fitting washers are at fault. it can be the banjo end where its soldered on the line. i have had the same thing happen on my 660. thought it was the washers but it was the line. replaced the line and all was good.
 
Try the 11354 copper washer, it's a bit larger to cover the area where the port MAY be chipped away. MAKE SURE there are TWO washers on each banjo fitting so the bolt CAN NOT bottom in the hole. Just ONE washer left off, and you WILL seize the hydraulic head when the bolt bottoms, and you WILL break the drive shaft. I repeat, the bolt IS NOT designed to seal on the bolt end, but at the two washers. It won't be leaking at the brazed line end like other engines use as Oliver/Waukesha used the long banjo extension line/Ermeto fittings.
 
Whoever told you that is dead wrong. One of the seizure failures is shown in the head seizure service bulletin. Drive misalignment, dirt/water in fuel, too high transfer pressure, plugged injector, and the bolt BOTTOMING OUT are all possible causes of any head seizure.
Anytime I get a pump in with a broken drive shaft, I press/cut the old head apart to find the cause, as I don't want the repaired pump to seize again.
 
Oops, sometimes I should keep my fingers off the keys. I remember now the reason we had ground the bolts was rthe washers we had were getting crushed pretty good and we ground the bolts to make sure that they did not bottom out on the hydraulic head and cause the issue Dieseltech is talking about. I remember we were swapping a used engine into a tractor and also had to swap the pump. Should have got new sealing washers. Sometimes the farmer way is not always the best way. Again sorry for the misinformation. : > (
 
Thanks for the reply. We got it taken care of. We had some 10mm copper washers for banjo hydraulic fittings that did the trick. They were about 2 thou bigger on the ID and a half a thou thicker than the stanadyne washers and they worked perfectly.
 
Nice video to finish your series, Tractor looks and sounds super sharp.
How did you get that oil pump to put out that pressure?
Congrats on your project, GG aka Wes, (Bailey) in your comments, I am his Dad.

we are winding down on the short end of finishing his 1800c 310 diesel overhaul....
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top