Disk Identification

[wenning]

Does anyone know what brand or model this disk is and if you could send me a picture of a restored one also my only leed is that it might be a MMoline

 

[CENTAUR]

That ratchet adjustment looks like a model 10a IHC that we had in the late 30s with wooden bearings which I opened up to see what they looked like after a couple of years and they were just like new.I was ammazed how long hardwood lasts if it is lubed. CENTAUR

 

[msb]

Its an IHC. I used one as a kid behind a Farmall M.

 

[georgeky]

Could also be a 9A. They look almost just alike. Don't think the 9A has the wooden bearings though.

 

[Anonymous-0]

If the angle arms that adjust the rear gangs run on a slide it is a 10-A, if they run on a roller then it is a 9-A. We sold a lot of 9-BAs. They had 9.5 inch spacings on the front gangs and 7.5 inch spacings on the rear qangs. Yes, each rear gang had one more disk on each side.

 

[georgeky]

Mingo, that means mine are 10A or B then as they have the slides. They also do not have any wooden bearings in them. I know lots of old disk did have, but neither of the 2 sets I have do. They are very good harrows though.