electrical question (12 volt)

bradley martin

Well-known Member
Last night, working ground. lights on tractor suddenly failed and "generator idiot light" came on very bright. Tractdor is equipped w/ single wire Delco alternator. After turning light switch off for about 2 minutes, tried it again and lights worked fine and idiot light went off. What caused this? Where do I start looking for problem?
 
I am curious how your idiot light is wired with a one wire alternator. The lights going out sound like a circuit breaker opening and resetting.
 
I wondered the same thing about the idiot light. Some equipment that case makes has a warning light that is hooked to a sensor that senses low battery voltage and turns a light on. Maybe there is something like that going on. mEl
 
Sounds like there could be a short somewhere in the lighting circuit. Perhaps the fault self cleared or circuit breaker action occurred like Tom described.......

John T
 
I'm wondering same as Tom below: How is the idiot light wired up? (The Delco single-wire alternator does not have provision for an idiot light).

My guess is same as John T - an circuit breaker inside the light switch opened up and killed the lights. It then reset itself after it cooled so the lights again worked.

And the idiot light is wired across the light switch so when the internal breaker opens it causes the idiot light to come on.

I can think of no other plausible explanation...
 
WHY keep the make/model of the tractor a SECRET from those who are trying to help you?

Besides what the others have said, check the belt and pulleys for wear. (If the belt is "bottoming out" in the pulley grooves it will slip allow the alternator to ssslllloooowwww down under load.
 
Would really help to know the make and model of the tractor. I see two possible ways, one being that the tractor is new enough to have a low voltage light (like my 85 model Steiger) and the one wire alternator was not able to handle the electrical load which allowed the battery to get low enough to light the low voltage light. Thgat would not explain the headlights going out though ?

The explanation of an idiot light fed from the lighting circuit downstream of the breaker would explain the lights going out and the idiot light going on.

The outfit where I buy my "1 wire" Delco SI series regulators includes instructions saying that if the user wants a working idiot light or wants lower excite speed, that you only need to wire the #1 regulator terminal to the idiot light. This converts it to a "2 wire" alternator. These regulators do not need the sense wire, but you might as well also install the #2 sense wire, Then the wiring is in place for the time when the alternator or regulator is replaced with a stock "3 wire" unit.

That may be the situation in this application, where the "1 wire" alternator is actually wired as a"2 wire" unit.
 
If the lighting circuit has a breaker in the feed line, and the idiot light is fed power from downstream of this breaker, having the breaker open would power one lead of the gen light from the alt #1 terminal and ground the other lead through the headlight filiments. This would light the idiot light as long as the alternator was charging and the lighting breaker was open.
 
Thanks for all the replies. I didn't state that the tractor in question is a 930 Case as I did n't think it wa relevant. Originally equipped w/ a generator, later a 3 wire Alternator and currently w/ the single wire. Until I remove the dash, I cannot say for sure how it is wired..alternator wire obvilusly runs through key switch. ..wire from bat to switch runs through a circuit breaker and light circuit is protected by in line fuse..
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top